@mattbeels I’ve not given you my email address yet have I? Here you go, send me yours if you want to. 👍 riffraff2020@mail.com

What’s up with your fingers? @mattbeels Just edited out my finger prints. I’m so paranoid these days, identity theft. Someone with some fancy software could digitally lift fingerprints and potentiall...

@boo What’s up with your fingers?

@boo These are handy looking tools. I'm sure I can use my dremel with it's plunge base to get me a straight hole to start with, then open it up with my step drill.

@robin I use these tools in substitute for a decent drill press. Attachment : 5E4B2962-19BB-40A2-96C4-E1E7EAAA6191.jpeg Attachment : 584CC08D-D6F9-4462-AC94-32C133EA3F33.jpeg Attachm...

Hi @matt I guess you don’t know anyone with a drill press? Maybe someone here could whiz up a drill guide out of scrap wood and send it to you? Something like this: There's a couple of local workpla...

Yeah, you suck @robin 😂😝jk... I guess you don’t know anyone with a drill press? Maybe someone here could whiz up a drill guide out of scrap wood and send it to you? Something like this...

Simple temporary jig but effective. It will wear out eventually. Just simply make another. Just make sure scraps are square to start. Hi @Clinton, that is actually the method that I used. I'm obvious...

@robin, Attachment : IMG_3518.MP4 Simple temporary jig but effective. It will wear out eventually. Just simply make another. Just make scraps are square to start.

@robin Yeah I hear ya, can’t argue with that.

@matt but you might consider removing a little wood with a file or reamer to get them in there, it shouldn’t take too much?!? I did consider that, but don't want to have loose sloppy fit. I'd rather...

@boo Top drawer Robin, I’m proud of you for being proud of what you have done. I'll take that as a compliment, I think!

@eddie6string I always drill undersized holes where possible and finish with a taper reamer. It can allow you to correct minor errors like yours I like that idea. Hopefully I'll be reunited with my...

@Rocknroller912 In the photo at the top I noticed that you have a router. Or if a drill bit is too long you could use a small diameter router bit. That's the way I'm thinking. I've also got a plung...

@robin Or if a drill bit is too long you could use a small diameter router bit.

@robin In the photo at the top I noticed that you have a router. Router bits usually have a 6mm shank, so you could put a 6mm drill in the collet and use it to drill vertical holes once you have plugg...

Ouch @robin, that sucks! Sorry to hear about that! Best of luck with the repair, but you might consider removing a little wood with a file or reamer to get them in there, it shouldn’t take too much?!?

I always drill undersized holes where possible and finish with a taper reamer. It can allow you to correct minor errors like yours Attachment : 16120996148063319099191688998953.jpg

I've drilled all 6 holes consistently off square and the tuners won't sit flat. That's a bummer @robin. I guess it's yet another learning experience. Cheers, Russ 🎶🎸🙏🙂...

Build #002 had been going so well until I did a trial fit of the tuners yesterday. I've drilled all 6 holes consistently off square and the tuners won't sit flat. I couldn't use my bench drill, it's o...