Neck angled and bolted on and all checks look good……..so far. Cheers

Starting to resemble a guitar now. Ave got the tenon and alignment done now. Going to tackle the angle tomorrow but I’ve sent mark a question about it just to clarify things. Anyway here’s where I’m up to. Thanks

[Read more]

Thanks Mark

Hi. Just been fast forwarding through the videos and see that Mark makes reference to a label which he glued inside the body. Somewhere there is a pdf of this label or something similar and I would like to make…   Read more»

Thanks Bpower. That’s exactly it. Thanks for your help

Hi. Can anyone remember which video contains the strengthening of the x braces with some type of material across the joint. Thanks

Neck pocket now done and also a final sanding all over with fine grit paper. All put away now til new year then it’s onto the neck join. Merry Christmas and happy new year. Cheers. 

@markbailey thanks mark

At last something that resembles a guitar body. There a few uneven bits around the sides but I’ve got them as good as I can with my limited knowledge and ability. A bit more sanding required and the neck joint…   Read more»

@markbailey yes it was. I managed to source some nearby after I trashed it on the first attempt. Slow progress but getting through it. Thanks

Hi. Finally the back is on and it’s fingers crossed that all is well. Quite a nervous wait till the strapping etc comes off Hoping and praying for a good outcome  cheers