@rocknroller912 I’ll give that a go and see how I get on. I’ll likely need a cabinet scraper to finish it as I don’t have anything to do that with and my plane is only about 40mm wide.

@tej Ive made a very rough sketch of how I would estimate the finished taper in wood. Hope you can understand it. Lay a ruler as shown from the tape to the front of heel and put your wood shim along s...

@tej Ive made lots of shims by hand, it’s not that hard. Start with a piece that’s longer and thicker than you need and clamp it to the bench. Then plane or scrape it working away from the clamp to cr...

@rocknroller912 I think what I’ll do is like you said, use some masking tape to get an idea of the angle I need.Not sure of the best approach to making the shims, the table saw would give accurate res...

Posted by: @robin I hadn't thought about the screw holes being out of alignment, we so lucky to have helpful people in this group. @robin I’d have considered that, admittedly just after I’d put the ...

@tej Even with the fretboard overhang and pick guard covering thing I would still try and fill any gaps in the joint, or the string tension will be pulling on the screws only which will probably cause...

@tej I was going to suggest removing some wood from the back of the heel to get the angle that you want, but I see you've considered that already. It would drop the neck deeper into the pocket though...

@boo thanks, I’ll have a look through those, I’ll not be buying from there though, way over priced. I feel I could make similar myself which will possibly only remain true until I try 😬

Have a look at these @tej There is some info on there too about neck shimming. 👍

@tej Good luck I’m sure you will get some other opinions

@rocknroller912 lots to think about there, it’s just the angle that needs raising so adding depth to the front edge of the heel. (Or arguably reducing the back) There’s no issue with a gap the fret bo...

@tej Are you thinking of raising the whole neck with a flat shim or changing the neck angle with an angle shim. If it’s a flat shim then you could add it to the pocket and route to the depth you need,...

Hi, I’ve a Tele copy where the action is too high, if I lay a straight edge over the frets to the bridge the angle is too low. Any tips on how to make an accurate shim to fix this please?

@boo I’m planning a 3 colour sunburst body sometime probably after the winter unless I can find a good way of heating my garage up to temperature, so I might need to pick your brains. I have yellow an...

Posted by: @rocknroller912 Your impact is very positive for sure. I had never heard of isolator paint before, although I’ve done a lot of wood finishing. @rocknroller912 Thanks. I guess isolator is ...

@boo Your impact is very positive for sure. I had never heard of isolator paint before, although I’ve done a lot of wood finishing.

Posted by: @rocknroller912 Thanks for sharing this, it’s giving us all a free masterclass in painting @rocknroller912 No probs. Painting is like voodoo black magic sometimes and it’s just finding th...

@boo Thanks for sharing this, it’s giving us all a free masterclass in painting

Couple more coats and it’s looking much better. I’ll let it settle for a couple of days and sand it, again. Then I’ll check to see if it needs even more primer. Attachment : 23061B53-EF88-4486-AA...

Okay, I ditched the “amateur” rattle cans (nearly) @robin 😂 I did use more of the isolator (rattle can), let it dry and sanded it back, ready to take some nitro primer. Attachment : 7C07B...