Either that or I’m putting too much lateral pressure on the saw and pushing it off line. @tv101 Yeah I had to be careful with the aluminium clamp I used today for moving, especially as it was clamped...

He went to the pub. I won. @tv101 Well, if you snooze, you lose! 🤣

Well, if you snooze, you lose! Snoozing had nothing to do with it @boo

@deej and I had a little challenge going, He went to the pub. I won. I think you’ll find @TV101 that I won 🥴....🤣

@robin

@tv101 There is another method of drilling to insert a metal ring using a double ring drill. Violin bow makers use them to insert a Sterling Silver ring into the ebony bow frog, sometimes with a pearl...

I’ve seen just uninstalling this tube as you would a dot and then fill the inner with ebony and superglue or an ebony dowel. And I’ve not had a drink...bloody iPad auto correct.. Should have been ...

After a bit of a delay waiting for my hide hammer, a trip home for my wife's flu jag and then a loss of phone signal/internet, I'm back. Attachment : 20201009_121530.jpg Iv'e adapted my headsto...

This is the one!

@boo Thanks Look forward to seeing yours. Psydelic Lady review Somewhere on this channel

@Tv101 I’ve seen just uninstalling this tube as you would a dot and then fill the inner with ebony and superglue or an ebony dowel.

@tv101 After Sat’s session, I’ve been trying to think of ways of just cutting a ring into the board ... How about using a circular cutter, cut a circle in a piece of plywood of a similar depth of th...

@tv101 @deej Tried out my idea of burning the ring into the wood and it worked not too bad, better in ebony than rosewood. I should have cleaned the burr on the brass tube from cutting before gluing t...

@tv1 @deej After Sat’s session, I’ve been trying to think of ways of just cutting a ring into the board ... One way of making a ring without a centre guide might be to heat the metal tube and burn t...

After Sat’s session, I’ve been trying to think of ways of just cutting a ring into the board ... @tv101 I know what you are striving for, it would be good but like a mark said, I fear the cutter woul...

Booked for collection tomorrow, so should be with you a few days after that ... @tv101 That’s great Tony, thanks. I’ll look out for it and try it out as soon as I get a chance.

here is my schecter Nick Johnstone guitar... ebony with brass and ebony. Looks stunning

Attachment : 475C3ADF-CDAB-4CA8-862A-791798CF3BBD.jpeg And the picture...

@eddie6string I do like a bit of psychedelia. ✌️🎶🎸🙂

Already sunk then @TV101.. oh and last post was straight edge....edit still not working...