Then I bent the sides into shape using the pipe bender. I then held them in place in the guitar mould.

🙂🎶🙏🎸

Then plane the edges flat on the shooting board.

🎸🙏🎶🙂

Then cut into shape on the bandsaw. 

🙂🎶🙏🎸

Onto the sides now. I used cherry for the sides on this one. Planed and scraped down to 2.0 – 2.1mm thick. 

🎸🙏🎶🙂

@Koendb that looks like an adequate compressor for small jobs like finishing a guitar. Go for low volume airgun – that way you wil have more control over the thickness of the finish layer.  High volume is more suitable for…   Read more»