Ok so Design #3 is on hold for now. Since Design #4 has gone beyond where #3 is currently I’ve decided to continue on with #4 and after that I’ll come back to this one. Need to focus on just…   Read more»

I have the neck for this one almost ready to glue in but I’m still a few steps from that point. I’m carving the back of it and shewee, 80F/26.6c and a whopping 84% humidity. And I’m not done with…   Read more»

Hi Kalimar, You’re right, you just have to watch carefully, measure the amount of material that needs to be removed and adjust the depth of cut accordingly and in small increments. I stopped before the cut reached the line at…   Read more»

@steveh I solved that issue with some 10mm acrylic sheets off ebay, now I can hold my router very flat while routing. Did it to both my palm routers.
 

@steveh I always do that kind of (tempate) routing on the routing table, if possible. For me it is far too easy to wobble with a handheld router and tilt it a bit. On the other hand, the router table…   Read more»