Then I used the router and binding jig with a flush cut bit to trim the back and soundboard flush with the sides.

…….. 

🎶🎸🙏🙂

Then I glued on the soundboard using the go-bar deck again.

🎶🎸🙏🙂

Then I marked out and cut out the notches to accommodate the braces of the soundboard.

………

🙂🙏🎸🎶

Next I cut out the notches in the kerfed lining to accommodate the back braces ready to glue on the back of the guitar.

Then glued on the back using the go-bar deck.

Then sanded down the inside…   Read more»

Then finished off using a sanding stick.

……..

🙂🙏🎸🎶