Get some neck-blank sized scrap timber and try the bit on that first.  Then get another…   Read more»

Job #1 – fit the cavity covers.  Mainly so that I could trim the edges of the back-cap, and do the roundover on them.  Wanted to have a consistent roundover all the way round, including the edge of the control…   Read more»

I glued the back-cap on last night, and used a few clamps to prevent a recurrence of the gappy join …

  That seemed to work. Had to take the car into the dealer this morning for some warranty…   Read more»

I like the curves on that design @nsj – I can’t do anything quite like that on this build, but I had something similar in mind.
Also really like the fact that you use proper cavity covers on your builds!!

@tv101 Here’s what I do to the neck heels area on my builds, I use 38mm screws from axesrus then I can do a 20mm neck heel and take the body down to 20mm at the join. Makes it really…   Read more»