Posted by: @rocknroller912 That looks very good. I think I will start using bolts instead of screws I’ve used this sort of thing in the neck heel

Once those are inserted, they’re going nowhere, and you can remove and…   Read more»

Posted by: @rocknroller912 if you have any finer grade then try sticking some onto a flat surface and use that to take out the scratches  Good idea – I’ve got plenty of finer grade paper, I’ll give it a go.

Did someone mention control cavity ??

Yup, been playing with the CNC machine again!  

Not sure I’ve ever managed to get quite such a neat cavity cover fitting!  The slot in the top of the cover is…   Read more»

Option A

I’ll be putting a tappable HB in the bridge position – one of the bits postie brought was a chrome cover to put over the top of the black bobbin’d HB that I’ll be using.   Option…   Read more»

@tv101 
That looks very good. I think I will start using bolts instead of screws

@tv101 
if you have any finer grade then try sticking some onto a flat surface and use that to take out the scratches 

Tidied up the carving around the neck join

 
And got the captive nuts into the heel of the neck – in all the right places, properly vertical too.  

That neck is going nowhere.

Postie delivered a few bits and pieces yesterday.

Posted by: @rocknroller912 I hope can get a good edge on the power tool attachments. I’ve had a first attempt on the belt sander.  I thought I had a selection of different grade belts, but apparently I’ve only got 180grit. …   Read more»

@tv101 
I hope can get a good edge on the power tool attachments.