Love the superspeed videos – makes it all look so simple  😉

And in this heat too – ouch, that’s going to be “uncomfortable”.
 
Congrats on the second practice run at getting it all into place … third time lucky?
😉
 

Good news, found my hardware, turned out that it was in the bottom of a box that I hadn’t looked looked in because “I wouldn’t have put it in there”

 Thats the electrics ready to be pulled into place….   Read more»

Here’s where I’m at with the tear out problem. Decided to trim the piece down a bit glue it back in, rough trim with chisels then sand it flush. Must say I’m pretty pleased so far. Means I can do…   Read more»

@brie You can also do a “climb cut” (going backwards) on certain sections to minimize the risk of tearout, but I think that is a scary thing to do with a router. I think Mark showed and explained it in…   Read more»

Thanks for the replies guys. Been having trouble getting logged on, hence the delay in replying.
Next passes with the router much shallower, then a pass with the bottom bearing bit – that might have to be a deeper cut.