@markbailey, @rocknroller912,@tv,@russ,@boo,@k I’m at a loss here for ideas..if i sand and lower the saddle, i’ll have NO break angle to the tail piece and fighting buzzing on the cover plate…i could put a riser on the nut and use…   Read more»

@tv101  With poor state of my fingers at the moment, calling anything after them is sure to end in failure. For your carve top I would rough out the carving with a cnc but do the final finishing with hand…   Read more»

Don’t bugger your back up again @nsj. 😬
🙂🎸🎶🙏

@jamesbisset  So, the back went into the vacuum press, this time glued with a slow cure urea resin, and you heard me say on the video there were a couple of creaks. Sure enough, the next morning revealed that the…   Read more»