Attachment : 41c7z6W11FL._AC_SY580_.jpg Has anyone ever used one of these to drill a straight hole? Are they accurate? 🙂🎶🎸🙏

I used cheap router bits on my Bandsman build and ended up with a less than tight neck pocket - only needed a very thin veneer - down to a crappy bearing on a cheap cutter from eBay....

@darrenking @frocesterbill Thanks Darren & Bill. I think I will look to pay for some good quality bits. It probably works out cheaper in the long run if I'm not damaging the wood. 🎶...

I have some Famag brad point drills following a recommendation by a bald, tattooed guitar builder and they are very good but weren’t cheap and I bought router bits from Titman.co.uk - very large range...

but does anyone know what drill bits to go for in the UK? Hi Russ, For my money the DeWalt Extreme bits are very good value but can be a little bit ‘grabby’ in the larger diameters (10mm+) especiall...

Cheers @rocknroller912. I'll check them both out. 👍😁 🙂🎶🎸🙏

@russ This is another one. Their products are good I got an engineers flat surface with a test certificate accurate to 0.001mm, so they’re not a DIY firm.

@russ Try this place My job was buying tools for a professional workshop and I went for quality firms that supply industry.

I might have a wee holiday in Germanyland @tv101 and buy some of their stuff. They've still got a great manufacturing industry. 🧰🪛🪚🛠️ 🙏🎸🎶...

@Russ, I think Matt was offering to get them for us, from Germanyland, and send them over. He gets my vote for most community spirited forum member of the day. 👍

They look good @mattbeels but does anyone know what drill bits to go for in the UK? 🙂🎸🙏🎶

This is My Favourite Song For This Moment.......a wee bit quirky. 🙂🙏🎸🎶

Hi Tej, It might be more complicated than you think to adapt a table saw for fret slotting. The fret slotting blades are usually much smaller diameter than the regular blades and therefore you will ne...

They certainly supply me, and therefore, GMUK

More jolly Irish stuff

@rockpile99 Glad it worked out ok, sorry should also have mentioned that it’s not at all quick, your results look pretty similar mind. I had a small chip to sort too and had to craft a new surround fo...

Sending GCode data to a CNC controller is a bit like asking Marvin to open and shut doors! He’d probably find that depressing! It was a bit of a pita, because my main machine and the CNC laptop aren’...

It’s an old machine, but could probably handle a bit more work. Sending GCode data to a CNC controller is a bit like asking Marvin to open and shut doors! You could probably run your router from an M...

Any idea whether 3mm is close enough to 1/8” to be interchangeable Hi TV, it depends a little on the construction of the collet but it is more likely that a 1'8" collet could successfully take a 3mm ...

Cheers @darrenking Ive got 3mm, 4mm, 6mm and 1/4” collets. Any idea whether 3mm is close enough to 1/8” to be interchangeable?? My first project completed, but it took a little longer than I’d hoped...