Attachment : 20201018_021209.jpg Attachment : 20201018_021227.jpg Will never use 'Safety Planer' again! Relatively slow speed of Pillar drill caused cutter to grab the neck (thicknessing he...

@Tv101 I’ve seen just uninstalling this tube as you would a dot and then fill the inner with ebony and superglue or an ebony dowel.

That looks great @rocknroller912

@tv101 After Sat’s session, I’ve been trying to think of ways of just cutting a ring into the board ... How about using a circular cutter, cut a circle in a piece of plywood of a similar depth of th...

Brilliant idea, and great execution @rocknroller912. That looks like the solution to me! @markbailey - remember where you saw it first 😉

@tv101 @deej Tried out my idea of burning the ring into the wood and it worked not too bad, better in ebony than rosewood. I should have cleaned the burr on the brass tube from cutting before gluing t...

Are the rings CNCed - the grain looks continuous......

@tv1 @deej After Sat’s session, I’ve been trying to think of ways of just cutting a ring into the board ... One way of making a ring without a centre guide might be to heat the metal tube and burn t...

I’ll be at work but watching as much as I can...... Despite my best plans, the meeting that should have finished at 1pm overran to 1.30. And then one of the people on that call wanted a 1:1 immediate...

Thanks for the update guys. I will try and catch as many live-streams as I can, work has gone nuts!

Thanks Bailey Team

Seconded!

I think that gratuitous emojis should be charged at 100 hero points each!!

Posted by: @ OH No. 😱😱😱😱😱........found some more lurking in the bottom of my emoji sack. 😉

That’s used up your emoji quota for 2020........ Want to buy some more.....

🎶🎸✌️😋👋🤘🤗🙏🎉🎊🛠️🔨🔧🗜️ Just Checking that my emojis are working.

Feels quicker to me Mark. 👍

Hopefully some of you recognise the pic - it is the ‘Magic Place’ from 2017.....

So just link from Flickr......