Where abouts in the world do you reside I live in Belgium

@boo I am so grateful that you take so much time to explain in detail, even repeat things to make me fully aware of what I should be doing. I admire your dedication and patience

@boo it is rustins mahogany grain filler. The instructions on the can says : leave overnight to harden

@boo Yes crazy but I never claimed to be sane

I’m a numbers man spelling and grammar is not my strong point! I know it’s dear but I meant to put Deer ....spoiled the joke ..damn And it would have been such a good joke too .... what a shame .......

My shed is 8'x6', I'm making an L shaped bench. The bench across the back is 700mm deep, which is about as far as I can comfortably reach. The bench along the side is 490mm, that takes it to the insid...

I’m a numbers man spelling and grammar is not my strong point! I know it’s dear but I meant to put Deer ....spoiled the joke ..damn 🤣

😣 where’s that edit button!!! @TV101 start a petition

Oh and apologies for the ironing board in one of the photos...the missus mustn’t have put it away That should not be your wife's task @deej. Sometimes people really disappoint me with their outdated,...

There’s a vid somewhere of me fitting a Hannes bridge..mainly the back as that’s the hardest but well worth it.

My favourite song today (with Diego Maradona on keys): Wow @marcel! Keys played by the hand of God ...

This is My Favourite Song For This Moment....... time for bed. 😴🥱 🙏🎸🙂🎶

Right, so I've now also learned that this is a job better suited for during daytime, as now i can see more little nicks and dents.My guitar seems to have measles now 😉 Should this dry overnight? or sh...

@Boo Thanks for so much detailed explanation, seriously appreciated! So I started by sanding it down with 400, as I did not have any 320 left, in some spots I went through the primer, but that s ok. ...

@mattbeels Thanks it’s going to be tricky either way

18mm at the nut is really thin I’ve got 6.5mm of fretboard in the middle so about 19mm in total at the nut. This still leaves at least 3mm of material beneath the truss rod so I think it should be o...

Thinking cap is on about how to make a pick up routing template for a curved surface. @rocknroller912 Route the pickup cavities before carving?

@darrenking fretboard included

@darrenking 18mm at the nut is really thin. Be careful that the truss rod does not poke out. I would not go less than 20mm.