@cazdaz Umh, just wanna say Hey. Hello.

@cazdaz Good to see you here too Carol! 🙂

@bpower NO need to behave any different 😆 it's your forum and I am a guest ... it's me that needs to behave. ! I see alot of the posts and comments - it is a great wee community. Keep on kee...

@darrenking ...haha am hoping it wont be too long before i can give you all one of those "looks" haha 🙂

@bpower LOL !

@rocknroller912 that sounds great... see this is also kind of what I mean - am worried that some stuff will just be harder to get so if we can help each other that be great : )

@russ Thank you... I hope to be more useful than entertaining if possible but who knows haha ! 🙂

@cazdaz I might have a small supply of ash for solid bodies sometime in the summer, locally sourced near Lockerbie. If I can get it I will give you first look and see if it’s any good.

@bpower No

Posted by: @cazdaz Hi ! I am Carol from guitarmaking and am going start getting a bit more involved in the forum Now we are in trouble! Best behaviour everyone or we’ll get on of those ‘looks’!! xx...

@cazdaz.... so..... does that mean we have to behave on these forums now? he he he 🙂

@cazdaz. Great to have you join us here Carol. I'm sure your input is going to be very entertaining as well as very helpful. Best Wishes, Russ 🙂🎶🎸🙏

Hi ! I am Carol from guitarmaking and am going start getting a bit more involved in the forum 😀 ( is The Knob and Nut Arms still open for beers ? lol) I buy most of the materials, tools and p...

@robin I just left them in the mould and moved the whole thing.

@bpower A shut off valve broke and leaked onto my water tank... which leaked and flooded my shop. I woke up to an inch of water in my shop. Thats a challenge that you didn't need, I hope there's no...

Ok thanks for the reply. im afraid it might be closer to 1mm. but i will definitely add a couple of extra side braces. need to figure out how to clamp them up from inside the body. could use CA glu...

so..... what a day so far...... I've been slowly working on this build. It has been coming along pretty good. I have the front and back done and ready for the sides. I have the sides done to the poin...

@seanwhcraig. I would say that you should still be fine. 1.5mm is thin but you didn't go through it so I think it is ok. On the course Mark says he thins the cutaways down to .080" so that is around 2...

yes, good point. it is an acoustic guitar. thanks

Have an OM that I'm working on and think in leveling the sides I got a little thin in 2 spots. I had cut a small channel so I wouldn't have to sand the top and sides end grain when leveling the sides...