@michael-oconnor Really nice work there Michael. Looks great. 🙏🙂🎶🎸

Wow - I just watched the 20min video. What a huge amount of time and effort - and skills - you've put into that rebuild. Don't think I've seen someone disassemble, and then rework, an acoustic in tha...

Attachment : 1942 Finished.jpg Happy New Year folks! I finished this job with the Eko Ranger in October but didn't get round to posting a picture yet. If you want the full story and more images, ...

@russ Electric to start with, then who knows?!

@tv101 Yes, I think I need to change that user name!!🤣👍

Hey up Brian, also North east Scotland here

@brie Welcome Brian. You've got a wee while until it gets warm up in these parts so you can watch through all mark's videos and then watch them all again. It's a good habit to get into anyway. Enjoy t...

Looking forward to seeing what you build Brian. If you follow the course, you really can’t go too far wrong.👍 (Your chosen username will make it tricky for people to tag you in posts)

Hi Fellow builders, just signed up for a 1year membership yesterday and I'm getting used to navigating the site. Been dabbling with guitar builds for a few years now, kit guitars and rebuilds. Decided...

This is My Favourite Song For This Moment...... I'll go with this version. 🎸🎶🙂🙏

@tv101 totaly! Watching other people on youtube and getting inspiration to improve my results!

That sounds like a good couple of hours work ... but worth it for all the extra enjoyment you get from a much easier-playing guitar.

Right, decided to get on with the levelling, crowning and polishing of the frets before attaching the wings, loads easier. Levelled and crowned Attachment : 20230215_193433.jpg Then onto po...

Looking good @nsj. 👍 🎸🙂🎶🙏

Today was good, got the fret markers done, then frets in and finally side dots. The new tools are helping a lot, hardly any levelling required after fretting due to getting everything so straight and ...

@tv101 Use the tubing, cut teeth in, drill it in then cut it off and file flush. Then start again, cut teeth, drill etc. That might work

It's very effective @nsj - works well 👍 I did some experimenting with the CNC with a similar idea - except I was just cutting the channel in the material and avoiding the step of having to f...

@tv101 yeh alumium tubing off ebay, 6mm with 4mm internal diameter. I also got smaller stuff for the side dots, had to sand a 2.5mm drill bit down to about 2.4mm seeing I could only find imperial but ...

Those “dots” look neat. Is that hollow rod with the middle filled in, or something else?

Trying out something different for fret markers and side dots, although I'll need a 3/32 dril bit for the side dots as they're imperial. Just used a 2.5mm to try out. Attachment : 20230213_16225...