Posted by: @nossair so does the volute size matter or you need just some extra mms to make the neck stronger? @nossair It depends on what kind of guitar. If it’s a standard guitar I would say it’s ...

Posted by: @tv101 Thought we were going to get some candid shots of Boo topless in the sunshine. @tv101 That would cost you money. 😆

It’s such a nice day, I couldn’t resist a few photos in the garden. ☀️ Attachment : 86050556-9609-4C72-AEC9-955591BBD93F.jpeg Attachment : 8A82A391-1389-4C59-AEFB-CBFB20443A19...

I’m working on sanding the radius into this fretboard today, it’s a beautiful, warm, sunny, spring day. ☀️ Attachment : CF19B4A3-F715-4CD6-B9F1-9105BA5EC530.jpeg Attachment : ...

Hello @nossair Welcome to the forum and well done building your guitars. 👍

Posted by: @bpower Thats like a survival pack @bpower Indeed it is. A man can’t survive without beer, snacks and bog roll. 😆

This thread is turning into a body repair shop. I’ve just discovered another problem, the jack plate route is slightly too big to get both screws in so I’ll have to build up something at one end to a...

Posted by: @tv101 You don’t need to mess up another back plate - some 3mm ply* could do the job just as well? Or, use some 6mm ply* and hollow out the underside, then you don’t have to worry about s...

Posted by: @tv101 I like that you keep your Sizzlin’ Extra Hot Pringles in the fridge. Wise move. @tv101 Just above, on the next shelf, is the toilet roll. 😆

What do you think @markbailey ?

I have another problem. As I am putting a trem in with a much bigger block, the springs are sitting high and proud of the back of the guitar body. I’ve been pondering over it and thought of one solut...

@bpower and @tv101 Yeah but it’s even better if you can get your wife to buy the snacks and beer. 🙌🍟🍕🧀🌶🍺🍻 Attachment : C6B06D85-0BE3-4AFE-A7...

It’s not a bad fit now at the sides, as far as the springs are concerned. Attachment : 2A9D6776-E401-430A-87E1-994F7D2AF3BC.jpeg Attachment : 45313392-4D12-4207-9EC3-B7E98E5B98AF.jpeg

More snagging work. I’m using a trem with a bigger block so one of the springs was seriously catching on one side of the spring cavity (I forgot to take a picture). I had to get the router out again. ...

Posted by: @clinton Do you wet sand with the 3m pad? Is it too abrasive? If so, do you put dish detergent with the water for lubricant? @clinton By the way, when sanding sanding sealer, you don’t ha...

Posted by: @clinton It freakin worked! Did your advice on grain filling, opening the grain and sanding sealer step by step. Thank you thank you thank you. Finally my dilemna with swamp ash solved. @...

Posted by: @nelbo Lucky enough to be in Ayr with Mark and Carol building a Moonshiner @nelbo Hey man, this is wonderful work and yes you are very lucky indeed. I’m glad you are enjoying it. Keep goi...

Slight miscalculation with this body. The trem cavity was slightly cockeyed so back to the router, all fixed now though. Attachment : 631F63B5-6535-4476-B64A-CC55B45A3550.jpeg Attachment : ...

Posted by: @tv101 Just about anyone .... @tv101 Yes. 😉