There's a Dry transfer paper available (Developed in Japan in 1980s) that just leaves the ink + microlayer of adhesive. I use it for my 'Electric Lady ' logo. Attachment : 20201127_212359.jpg

Wrong image!!! Try again Attachment : 20210128_122507.jpg Custom finish on BKP Cobra Pup

Attachment : 20210127_144703.jpg Current thinking

Attachment : Screenshot_20210127-231550_eBay.jpg Like this Pickguard

Attachment : 20210127_144703.jpg Newest build English Ash grown in Swampy conditions- see width between annular grain! Body about 3lbs Birdseye Maple Neck and Fingerboard EVO Gold frets Water-ba...

On the subject of stolen riffs - the reason I took up Electric Guitar was this egotistic, yet talented guy Ritchie Blackmore. Understandably 50% of riffs I wrote had his approach , so I came up with ...

Paint brush dipped in water on inside of 10mm has worked for me (end grain will remain expanded/swollen), but 9.5mm usually works fine for me.

Attachment : Screenshot_20210126-023206_Gallery.jpg Sliced and Diced doesn't require symmetrical design

Methinks it will make for the coolest coffee foams. More Sugar with that vicar ?

Attachment : Wood dots.mp4 Better view

Attachment : Screenshot_20201224-005800_Instagram.jpg I used 6mm plug cutter to make Maple & Mahogany dowels for one of the Necks in pic. Careful to align the grain. I think with metal surroun...

Sorry for typo Rockpile 99

Thanks Rockpile 92 I'm the same scenario as you - miss my olde workshop! Most of the time it works well, it's the cure time that drives me to distraction!!! The proverbial Guitar builders' string of...

I'll share this week's disaster with you - Final rubs of this P Bass with 1,500 - 5,000 grit prior to buffing. Wipe off with damp cloth to remove residual dust/sludge and let it breathe off for coffe...

Is it possible to do a decorative carve and fill with epoxy then reshape? You'd have to stop anything bleeding into channel. Could be a very cool inlay

Nicely done. Truss rod routing is so rewarding when it sits in the groove all snug! Getting a tight fitting square level Nut is my current nemesis

Attachment : 20210122_201247.mp4 Idigbo Neck Maple Fretboard SS frets Abalone 4mm dots

Cautionary tale: When building the prototype Electric Lady Signature model in 2009, I thought how cool to extend neck to accommodate supporting 22nd fret. I made the mistake of using the standard gui...

Coolio!

Thanks