@bpower Well, my house and garden are covered in them again. It will look great at Christmas though. ✨✨🎄🎄

@boo yeah. I'm just having flashbacks of elementary school and how irresponsible I was with the glitter. I think I'm still finding some almost 40 years later. 🙂

Posted by: @bpower oh my.... wow.... I would sooooo never be able to use that stuff. One sneeze and..... eek. @bpower Yeah, I normally wear my mask when mixing flake and paints, it’s a health and sa...

@boo oh my.... wow.... I would sooooo never be able to use that stuff. One sneeze and..... eek. 🙂

Dancing flake. ✨✨✨✨

This time I’m using a mix of large silver flake and holographic micro flake (rainbow spectrum colours), mixed into clear basecoat. Yeah, this time I’m using a wet application, employing a gun with a 2...

OMG!

First attempt at the neck shaping. Layed all the neck parts out and did some marking up. Neck, fretboard, nut blank, headstock veneer, and truss rod. And, I got a little excited and started cutting t...

Glued the scarf joint today. It may or may not come out good, I'll know tomorrow when I take the clamps off and start checking it. If it's good and tight, then the game is on to measure and see how mu...

Couldn't find good quality 4 pole bobbins and the 8$ 4 pole pickups for cigar box guitars do not fill me with confidence. I cut out the center two strings from a repro set of PAF bobbins, and glued t...

First fretboard tapered and fret slots cut. Gonna make truss rods this week, fret board is 11.5" and so I'm looking at an 8 3/4" truss rod.

@wolframmalukker very nice looking pieces of wood. 👍

Cut out the first two fretboards today. Seemingly silly mistake to taper them first but they fit into a slide in the fret miter box, to keep them square. The board stock was not wide enough to not cut...

Fantastic! Fav quotes: I can even hold it and I don't know what I'm doing... Getting there!

Great video Steve!! Looking good...

@powerful - I did answer this Q including dimensions here if you missed it...👀 short answer is - don't worry, doesn't matter, make it whatever you like:

Thanks mark but it’s sorted. Maybe you can tell me the depth of sides at the deepest point ie lower bout area. I’m going with 100 mm before bottom goes on. Am I somewhere near. Thanks

@powerful We can send you replacement kerf lining - email carol@baileyguitars.co.uk if you are stuck - cheers!

@powerful David Dyke is my number one supplier now for anything I can’t get from Bailey or wood where I want to do the jointing myself.

And it’s ordered. Sorted thanks