@tej Only concern now is that the bridge is a very tight fit in the mount holes, I hadn't masked off the bridge post holes when I lacquer my current build, so the holes have shrunk with all the lacq...

I’m not putting a reamer anywhere near this build, bad experiences with them, if it comes to it I’ll make some tedious sanding tool and do it very carefully. I’ve some scrap to experiment on but I wan...

t was a little scary. @boo I’m not putting a reamer anywhere near this build, bad experiences with them, if it comes to it I’ll make some tedious sanding tool and do it very carefully. I’ve some scra...

Only concern now is that the bridge is a very tight fit in the mount holes, at least it is in the test ones, I meant to address that before I applied the finish but didn’t stupidly. Just hoping enlarg...

I’ve somehow missed all of this I’ll not take your previous silence personally @boo 😉 Only concern now is that the bridge is a very tight fit in the mount holes, at least it is in the test on...

@tej Hey man, I’ve somehow missed all of this, just caught up now. It’s all looking superb and you just have to work through the mistakes, it’s part of the job. I’m looking forward to seeing the finis...

Well hello there, after an uncooperative summer mixed with illness and isolation progress is now being made again. Top coats of finish now going onto the body and neck, pics to follow. Looking at abou...

@rocknroller912 yeah very displeased with my Frankenfinish! I took to it with the random orbital in the end and took it right back finishing by hand with the grain. First coat of deep colour went on w...

@tej It must be bad if you don’t want to show it. Scraping is sometimes better than sanding to remove a failed finish as sanding can just rub it further into the grain. I’ve been there so learned the ...

Sadly what I created was a mess @rocknroller912 I know what you’re getting at but that’s really not what it’d have come out like and is about as far away from what I wanted as you can get. No matter, ...

@tej Its difficult to comment without seeing a photo but not all instrument finishes are designed to be even all the way over, and stain often looks bad until the final finish coat. Sounds like you h...

@robin I had done, it just looked a mess, really uneven texture and colour. Just need to suck it up and start again.

, while sanding down the filler I caught the edges too much and took all the colour off them. Couldn’t get it back the same as the rest so literally need to sand everything back now I feel your pain ...

Well this is al getting rather infuriating, finish was going well until I added grain filler, it’s now a total mess, while sanding down the filler I caught the edges too much and took all the colour o...

Apologies to all for radio silence, not a lot to post about while I’m applying coat after coat of finishy coloury gloop, it’s all just more green than it used to be 🙂 As for the headstock logo...

A few minor scratches to get out now, then deciding when to drill the bridge holes. Also need to focus a bit of time shaping the tips of the horns as they’re a bit sloppy. Attachment : 90BE98F8-4E...

How do you like the EVO Gold wire? @mattbeels I love this EVO Gold fret wire. It’s great to work with and it looks great when polished up, as well as the colour. It’s becoming my goto wire, in fact I...

Thanks @mattbeels! 🙂

Genuinely excited to see your finished guitar mate, well done Thanks @cheesewhisk! Come on man! just do it, Before I built my first guitars, I could hardly drill a hole in a wall 🙂

@koendb that looks incredible, I really need to pull my finger out and glue my neck in. Every time @markbailey says 'be careful not to...' that's always where I end up 🤣 🤣 Genuinely...