I think I will be doing some more tomorrow! Make a jig and you can make a hundred guitars!

@peebee That's it now mate - one jig down, now you're hooked! There's no going back to your previous life anymore.....

I manage something physical today, my first jig. Cool jig. I think that was the first one I made.

Redrawn the posts in the correct position. @peebee Yeah that's better, exactly that. 👍

I manage something physical today, my first jig. Attachment : 20201209_135121.jpg Missed the live stream though.

Redrawn the posts in the correct position. Attachment : DD6051B0-6088-467A-85C8-4BB84A8B26F4.jpeg

Thanks Boo for taking the trouble to put these videos together. Very helpful and clear. I had cocked up, I had the bridge front edge on the 6mm line so as you say the posts would be too far back. just...

@boo thanks mate thats greatly helpfull

@peebee This video is for positioning the wraparound bridge in the correct place and to mark where the post holes are to be drilled.

This forum is great eh? Plenty of advice and help to be had, I am sorry I didn't find it sooner @peebee I’ve just made another short video regarding the bridge position for the wraparound bridge. I’m...

@peebee It’s looking good but I can’t see where the scale length line is. Make it really clear so you can’t overlook it. Also, if you are using the Wilkinson wraparound bridge, have you measured 6mm b...

@peebee Have a look at my video for the Wilkinson wraparound bridge and double check your drawing.

The drawing so far. Now just going to look at it and decide if it’s right. @peebee It’s looking good but I can’t see where the scale length line is. Make it really clear so you can’t overlook it. Als...

@darrenking router cutters described as being ‘plunge cut’ really don’t like being used as drills ie a completely vertical plunge A good point there Darren, I didn't know that.

@robin well Robin and Mark you may have the clue then.... I'll double check my pillar drill is not wandering and do another test with a very tightly clamped piece... Just goes to show how important to...

@clinton glad I'm not alone and yes, it's just a tad too tight with the 11m...I'll do a test with your method cheers Steve

@markbailey fair point but I used my pillar drill, seemed ok... I will do another test, by hand as well...although I dont really want to drill the final holes by hand and not get them straight It's a ...

Good point Mark, What brand of 12mm drill have you got Steve, not all tooling is created equal! Those TCT lip and spur drills are also available in 12mm and the hole will be spot on, guaranteed. Just ...

I came across the same exact dilemna. I ended using the 11mm and drilled it normal for the posts. I came back on on reverse moved it about a bit just to be able to slightly widen it.

More money, but in the UK and in stock!