Looks great! Headstock is awesome!

Thanks @boo I can see small swirly scratches shining through the lacquer when I turn it in the sunhine, I don't know if these would polish out or not but I think I'm going to leave it as it is, I'm ...

@robin That looks really good! Well done. 🤩 🍾

@robin Very nice work Robin, it looks great. I like its offset appearance and the colour blending is wonderful. I like your attention to detail with the truss rod cover and headstock decal, as well as...

I like how you have shaped the neck heel to the body Thanks @russ it didn't start off quite as close as that, but by the time I sanded out saw cuts and chisel marks thats where it ended up, so just...

Very well done @robin. I like how you have shaped the neck heel to the body. 🎸🙏🎶🙂

That's my build #002 almost finished now, just needs a wee tweek of the truss rod and the string heights set. This one was a kit from @markbailey and built following his course and lots of advice on t...

It’s water based so I just use a damp (not wet) rag, make sure the rag is soft and you have rung it out properly. Follow up with a dry rag and try not to get any water in any screw holes etc Thanks @...

Just one more question, what do you clean the G3 off with? @robin It’s water based so I just use a damp (not wet) rag, make sure the rag is soft and you have rung it out properly. Follow up with a dr...

Go through the grades of papers and then through the grades of polish, that’s the secret. Thanks again @boo for your usual comprehensive advice, very much appreciated. I've ordered up some wet &...

Attachment : EFECEB19-4C55-470B-BA64-4D95C0B61E03.png Attachment : 49E0918F-F679-4843-8A2D-281C8B7E47F2.png @robin You don’t have to use these exact ones, other brands are available. They d...

I think I'm ready for some more of your expert guidance. I've had a tentative go at polishing the control cavity cover and it looks quite good to me, but obviously I'm aiming for better than just good...

This is looking really good. I hope the lacquer turns out good for you. Looking forward to seeing this finished. Thanks @Wayne_F , its got all the lacquer that its getting, so I'm working my way up t...

This is looking really good. I hope the lacquer turns out good for you. Looking forward to seeing this finished.

All l can do is black inkjet waterslide and that took a lot of trial and error, I've got enough for my next four builds though. I tried colour too, but it was too see through. All that trial and erro...

@russ Your certainly my goto logo man All l can do is black inkjet waterslide and that took a lot of trial and error, I've got enough for my next four builds though. I tried colour too, but it was t...

Your certainly my goto logo man @robin. Very nice. 🙂🎸🎶🙏

Couldn't resist a little trial fit of the tuners @robin Looking good Robin, I’ve done the same thing with a truss rod cover before. Every day is a school day eh? 😁👍

Couldn't resist a little trial fit of the tuners. I need to build up more lacquer though, I can still see and feel the edges of the logos. However, I totally forgot about the nut when I was positioni...

My condolonces. Looking real good finishing.