Bish
 

 
Bash
 

 
Bosh
 

@tv101 totaly! Watching other people on youtube and getting inspiration to improve my results!

 
🤣 🤣 
 

@jamesbisset my dad had a 1965 es330, intersting stuff that

Right, decided to get on with the levelling, crowning and polishing of the frets before attaching the wings, loads easier.   Levelled and crowned

  Then onto polishing, went up through a few grits of paper, 320, 400, 500…   Read more»

Today was good, got the fret markers done, then frets in and finally side dots. The new tools are helping a lot, hardly any levelling required after fretting due to getting everything so straight and flat in the first place….   Read more»

@tv101 Use the tubing, cut teeth in, drill it in then cut it off and file flush. Then start again, cut teeth, drill etc. That might work

@tv101 yeh alumium tubing off ebay, 6mm with 4mm internal diameter. I also got smaller stuff for the side dots, had to sand a 2.5mm drill bit down to about 2.4mm seeing I could only find imperial but it works….   Read more»