@nsj I hogged out the bulk of the material before hand. I worked out to angle the bit & lower it gently after the first cut . Maybe my cut was a bit deeper than it should have been. I guess all ...

Attachment : guityar.jpg @nsj Thank you very much for your response. That clears up a few things. I am mainly using a palm router &, like you I have a 200mm acrylic base I have made to scre...

Could you explain what you mean by shimming it please?  

@benjaminschwillens82gmail-com Thanks that vid was very useful.  

@benjaminschwillens82gmail-com   Thanks again, that makes sense. I will have to wait until I have bought a fret board before I can move the neck on. The drop top I bought is very nice but t...

@benjaminschwillens82gmail-com Thanks for your response Benjamin.   I have bought a 5mm maple top & will add that to the front. Maybe I'll use the veneer on the rear. I'll procrastinate...

Hello. I'm just about to embark on my first guitar build & am seeking some advice. I'm planning on building a Tele because I'm thinking that might be simpler for a first time builder & also ...

Hello, new member here, just attempting my first guitar build. Lots of questions.