@robin
Hope all goes well Robin. 
🤞✌️🙂

Best wishes @robin – hope all goes well
 

@robin Speedy recover. For sure you will have simething to look forward too once you are up and running. 

@robin
Good luck with your surgery 

I’m having surgery on my stomach tomorrow

@robin I hope everything goes well for you, rest up easy until you are ready. 

I think that Mark has a video on making truss rods, so I guess you could make any length that you want. @robin Yeah, I think that was for a curved one though and for single action. I’m not sure…   Read more»

@markbailey 27/10/2020 10:12 am      @robin The earth can go to either post tailpiece or bridge – no difference – do what is easiest. I sometimes use a little epoxy in the hole if a little loose – superglue would also…   Read more»

@robin The earth can go to either post tailpiece or bridge – no difference – do what is easiest. I sometimes use a little epoxy in the hole if a little loose – superglue would also work but a bit…   Read more»

Nice @robin.
I knew it would come in handy one day!!

You’re welcome @robin.
I’ve got a stack of stuff that “will come in useful one day”.  At least that day will now be happening for one of those veneers!

@tv101 @robin – Postie should deliver a little package tomorrow.  Hope it helps. The postman has been, thank you again Tony for sending these veneers to me. Iv’e tidied up the truss rod access slot now and will glue on one…   Read more»

I seem to be doing it more than anyone else, 

I bet you’re really not @robin – I don’t think I’ve had a single build on which I’ve not encountered a “learning opportunity”!!

@robin I have made a lot of mistakes and I’ve learned to just accept that they happen. I think it’s only because some of us have built a few guitars that we avoid the mistakes that we have done before…   Read more»

Thats spooky, I watched that last night. @robin Hahaha….. I watched them ages ago because I had the same concerns. When you asked the question, I remembered about them but couldn’t remember who had made them. With a little hunting…   Read more»

@boo

@robin These videos are great. 

Thats spooky, I watched that last night.

I’m needing a bit of advice on bridge position.

@robin These videos are great. 
https://youtu.be/Zabgw_RBC-I

@markbailey

@robin For next time I’ll show you TODAY at 1pm how to make a veneer if you don’t have a Sander Thicknesser…

Excellent, I’ll be here watching.

@robin Deja vu…I was going to cover this today also! Spooky
@tv101 – Bang on! This is ACE – Hero points awarded

@tv101 Dang – Beat me to it – Cheers! @robin For next time I’ll show you TODAY at 1pm how to make a veneer if you don’t have a Sander Thicknesser… Go for it @deej! We are going to add…   Read more»

@robin – Postie should deliver a little package tomorrow.  Hope it helps.