Then glue in the four back braces.

🙏🎸🙂🎶

The next stage was to mark out each of the areas of the centre strip where each of the four back braces will pass through. Then carve them out

🎶🙂🎸🙏

Your putting us procrastinators to shame @nsj. 🤣😂 
🎸🙏🎶🙂

@peter-c-f
Keep us posted Peter. I’m keen to have a go at this. 
🙂🙏🎶🎸

I’m the same @swepri. I just borrow other people’s ideas. 🤣 
🎸🎶🙏🙂
 

Cheers @swepri The shooting board has a series…   Read more»

……then glued it onto the inside of the back 

🙏🎶🙂🎸

I used an off cut from the soundboard to make the centre strip for the back
🎸🙂🎶🙏

Then I cut out the shape of the back
🙏🎶🙂🎸

Then I plane on the radius of 20 foot using the shooting board. 

🎸🙂🎶🙏

Planing down the back braces flat and square. They are all 7mm thick and will eventually be 14mm high but I’m leaving them 20mm high for now. 
🙏🎶🙂🎸

…..then planing and scraping down to 2.8mm thickness.
🎸🙂🎶🙏

Joining the back. I’m using cherry for this one. 
🙏🎶🙂🎸