@liebe Thanks Dan, the unit was getting power from the battery, the tuner was working (therefore receiving a signal from the pickup) but the output from the unit had failed, or the cable between the p...

Hey Brian, Preamps can fall, but perhaps see if you can bypass the output from it to see if the output jack has failed or needs cleaning. I have a jack socket with two crocodile clips wired to it too...

Well, that went well👍😃 I solved the bridge pin problem by pulling the pin out as far as it would come, then cut it with my fret end nippers, which allowed me to knock it back through t...

Hi everyone, I started what I thought was a simple bit of maintenance on a Washburn EA16TS for a friend. The guitar has been stored in a case in the loft for a number of years and the brief was to che...

Loving your builds NSJ! that recessed jack connector looks really nice. And the 3 layer look mahogany, ash and black - so dope!!

@nsj Very nice looking guitar and a cool finish

nice build

hey

I will check it too

With osmo I finish the neck first then oil, that's what I did on the copper tele with oak board. Worked great.

Black Beauty! Very Nice Indeed.

Mahogany neck and body, ash top and headstock plate, ebont board, jumbo frets. Gotoh hardware and seymour dunscan JB4 SH2N pickup combo. It's one my favourites I've done so far.       ...

Hello all, I'm I'm working on a maple neck with a maple fretboard (bolt on). I'm at the point where I'm struggling on what order to do things, My fret slots are the right depth and my side dots are in...

Looks awesome, what a nice maple cap!

Nice job!

Nice job!

nice build

🤣 @brie you’re not wrong there!

Nice work Stephen, of course you’ll have to do another😂 it is addictive after all🤣🤣🎸👍

@nsj thanks for the tip and your kind comments. Good luck with your faux binding. I did not find it to be difficult. I used sanding sealer on the sides before staining the top right out to the edge, ...