I look forward every week to seeing what you and Mabbot are up to. You might just change your opinion @jamesbisset if Carol plays this week's contributions ... (mine, not Mabbbotttt's!).

Rather you than me @tv101. I’ve always had the luxury of sitting in the mix with a band...hides a multitude of sins (bum notes). I can’t sing for toffee neither. Hope you make some of the Bliss sessi...

Rather you than me @tv101. I’ve always had the luxury of sitting in the mix with a band...hides a multitude of sins (bum notes). I can’t sing for toffee neither.

Nice One @tv101. I so admire the nerve that you have to get up and do that. 🙏🎸🎶🙂

A little musical* interlude in a weekly on-line comedy show ... * obviously, that's up for debate! Nice one @tv101

A little musical* interlude in a weekly on-line comedy show ... And a very nice one! Thanks @marcel - that was more than a virtual compliment!!

A little musical* interlude in a weekly on-line comedy show ... And a very nice one!

Have you been able to do any practising during the lockdown years? Though it sounds/looks like quite a tight band, so I guess it'll all come back to you all fairly quickly once you can get back toget...

For the older folk: @jamesbisset I'm pretty sure I've seen and heard that very track being broadcast recently. Are you famous really? 😉 Really enjoy your Bliss appearances!

tv101 Enjoyed your music on Bliss last night, it was better than Radio Scotland.

Cheers @Tej - it's been a bit of a journey for me over the past few months. Not having done anything like this previously, the first few efforts were "treated kindly" by the audience!! Bliss last ni...

Played a bit with my miter saw and scarf joints on cheap wood. This is what I have learned so far: Since I cannot cut from anywhere in the neck blank, I would need cut the angles for the headstock an...

of course the angle is 15 degrees of a vertical axis. I meant to say 12 degrees, but doesnt matter, I was wrong :-/

Today I discovered I can also angle the miter saw blade vertically. So I actually don't need a jig at all.I'm gonna try that tomorrow! Well that was a bummer.. of course the angle is 15 degrees of a ...

Today I discovered I can also angle the miter saw blade vertically. So I actually don't need a jig at all.I'm gonna try that tomorrow!

@clinton oooh so sweet! That looks really good. I don't have a table saw nor a band saw. But I do have a miter saw. Today I worked a bit on some sheds in the garden, in order to move everything out of...

Sweet vid @clinton, the guitar isn’t too bad either! 😉

Beautiful @clinton. 👍🤩 🙂🙏🎸🎶

12 degrees is just right. Not too much not too less. Here is a link of a vid. In the begining you will see a jig I made for the tablesaw to cut scarves. Not recomended for the beginner. It is an angle...

@Mattbeels and @clinton Great, I ll stick with 10 to 12 then.Scarf Joint/No Scarf Joint I'll leave that decision until I m able to at least test this with some scrap wood and my miter saw.Either way, ...