This kind of talk will get you barred from the Knob and Nut before it’s even opened. I'm a rebel..........

@peebee Yep! You are really travelling down the rabbit hole now! Mrs ordered me a Bailey Electric Guitar kit last night too! I am going to be very cross once this Furlough ends!

Wot's that? The superglue and masking tape trick? Couldn't say! but possibly

the method that shall not be mentioned. Wot's that? The superglue and masking tape trick?

Headstock angle jig made out of 18mm MDF. First time using NEC floor tape too, much quicker than the method that shall not be mentioned. For the angle I measured as per the instructions on the course ...

@peebee @peebee That's it now mate - one jig down, now you're hooked! There's no going back to your previous life anymore..... Be careful though, you might end up building stuff like this from junk....

I think I will be doing some more tomorrow! Make a jig and you can make a hundred guitars!

@peebee That's it now mate - one jig down, now you're hooked! There's no going back to your previous life anymore.....

Redrawn the posts in the correct position. @peebee Yeah that's better, exactly that. 👍

I manage something physical today, my first jig. Attachment : 20201209_135121.jpg Missed the live stream though.

Redrawn the posts in the correct position. Attachment : DD6051B0-6088-467A-85C8-4BB84A8B26F4.jpeg

Thanks Boo for taking the trouble to put these videos together. Very helpful and clear. I had cocked up, I had the bridge front edge on the 6mm line so as you say the posts would be too far back. just...

@boo thanks mate thats greatly helpfull

@peebee This video is for positioning the wraparound bridge in the correct place and to mark where the post holes are to be drilled.

@peebee It’s looking good but I can’t see where the scale length line is. Make it really clear so you can’t overlook it. Also, if you are using the Wilkinson wraparound bridge, have you measured 6mm b...

The drawing so far. Now just going to look at it and decide if it’s right. @peebee It’s looking good but I can’t see where the scale length line is. Make it really clear so you can’t overlook it. Als...

DOH! glad I read this I nearly made that mistake!

make sure your tuners line up and that the horns on the headstock are not in the way of the pegs of your tuners. Looks like it may. I will do, thanks could’ve been a gotcha!

@peebee make sure your tuners line up and that the horns on the headstock are not in the way of the pegs of your tuners. Looks like it may.

The drawing so far. Now just going to look at it and decide if it’s right. I have a couple of bits of wood to practice the body on before committing. Attachment : 578D7875-A5F7-4A79-A45C-AE734F992...