I’ll look into those options and then cry (probably) when I see the prices! @mattbeels, yes, but according to boo the tools are so much cheaper that you'll be saving money every time you buy one, so ...

Played a bit with my miter saw and scarf joints on cheap wood. This is what I have learned so far: Since I cannot cut from anywhere in the neck blank, I would need cut the angles for the headstock an...

@boo yeah that is probably a lot cheaper and does the job just as well. I initially though of using my side level file, which has a 45 and a 90 degree angle, but the file is just a bit too thick for a...

Use that carefully and the bottom of the nut slot should be flat, and perpendicular to the end of the fretboard. ordered the 1/8" one straight away! thanks @tv101 Attachment : IMG_20210419_...

as the double sided tape didn’t want to let go You could also consider screwing them onto the blank using screw positions that correspond to the pick up cut outs or control knob holes (if these haven...

@marcel I found the track the first LP I bought, Beyond the Turning Point which I still have. Don’t have anything to play it on.

Suzy Bogguss is great she does a live stream every week on Facebook at 5pm Central time US. Wine Down Wednesday it’s called. Cheers @rocknroller912. I'll check it out. 👍😁 🙏&#...

This is My Favourite Song For This Moment........ The Coolest Band Ever? 🎸🙂🎶🙏

of course the angle is 15 degrees of a vertical axis. I meant to say 12 degrees, but doesnt matter, I was wrong :-/

Today I discovered I can also angle the miter saw blade vertically. So I actually don't need a jig at all.I'm gonna try that tomorrow! Well that was a bummer.. of course the angle is 15 degrees of a ...

Thanks for the info @boo and @darrenking I’ll look into those options and then cry (probably) when I see the prices! 😆

My favourite song today:

One of my earliest influences John Mayall This was the first single record I ever bought!

When can you ship? Give me a few days to incorporate the mods and I should be able to run an initial batch by the weekend.

if the front lip had just a little more surface area I'll just machine a square hole in either side of the rails big enough to get a small clamp through. Simples!

Might the middle tend to get more use than the extreme edges and wear more for example? Birch ply is pretty hard wearing and you'd probably have to surface rout several thousand blanks to see any not...

I wish I'd had one of these this weekend. 50mm seems on the money, the blank I had was 48mm at it's fattest end. I'd stick with a round 50 and then maybe you could look at an extra large version if th...

Thanks guys. @tv101 I'll give twisting a go next time, seems obvious now you say it but that's probably the same about a lot of thing. I went with a metal ruler then screw driver in the end, maybe...

Attachment : image.png

Attachment : image.png