GREAT IDEA! Leave it with us...we do have several sections 'unpublished' so I'll look into it...

?

I’m always confused and to be fair I’d has a couple of glasses of vino when I read the OP...makes perfect sense now ?

Posted by: @david-johnson09 ?? Autocorrect had autocorrected "trem" to "them" when I'd listed some suggestions of what could be covered in a new section. And because the edit button isn't working, I...

Posted by: @TV1010101 them aka trem, when autocorrect butts out! ??.....

Yup - good idea.....

One on them systems. them aka trem, when autocorrect butts out!

Great idea...anything that can share experiences with parts etc. is definitely worthwhile..

Sounds like a great idea One discussion on pickups - pros & cons of different brands, etc (like on your on-going build discussion) One on bridges - again, pros & cons of different brands, or ...

Sounds like a great idea

Prompted by the discussion in @darrenking's thread about his latest build ... I wonder whether it would be worthwhile having a new section on the forum called (something like) "Pickups & Parts"? T...

?

’m not sure it would work but if all the slots are off by 1mm you could but the bridge on off square Or just use it for playing Jazz .... ?

I’m not sure it would work but if all the slots are off by 1mm you could but the bridge on off square but 1mm... @markbailey may be able to advise on that..fir the price of a fretboard I would do as @...

Thanks Darren

Hi Seth, I am afraid that you have to ditch the fretboard and start again. 1mm out will be easily detectable and given how much work the rest of the guitar is going to take it would be crazy to carry ...

Yes its off by 1mm. I measured with a little $9 angle-izer.

Without getting my trig tables out, I don’t know the answer to this ... but I’m guessing that a 1deg error across the width of a fretboard is less than a 1mm error? How did you manage to measure a 1de...

Hi everyone, just started my first build, i was cutting the fret slots by hand and some of the slots are off by 1°. Is there a tolerance? Is there anything I can do, or is this fret board destined fo...

TV romping up the ratings by triple posting...... ? Think neck carving an first coat of oil finish are two magical bits in a build - I remember my first neck up at Baileys in 2017 - got the first san...