Apologies to all for radio silence, not a lot to post about while I’m applying coat after coat of finishy coloury gloop, it’s all just more green than it used to be 🙂 As for the headstock logo...

A few minor scratches to get out now, then deciding when to drill the bridge holes. Also need to focus a bit of time shaping the tips of the horns as they’re a bit sloppy. Attachment : 90BE98F8-4E...

@robin thanks, I’ve made both horns a bit thinner now too so the lower one doesn’t block things, it’s a little annoying still but overall I’m not going to spend “that” much time at the 24th anyway! Wi...

@tej Your carving is looking good. As for removing fingers, I've tried it and wouldn't recommend it.

@koendb I always wear a strap with the guitar quite high so I can have the neck at a high angle so there’s no strain on my wrist. On the rare occasion I don’t use a strap I’ll have it one my left leg ...

@tej I have the same issue with one of my builds. the cutaway should be a lot lower. It is also difficult to balance on my lap because of the weird curve at the bottom of the lower horn. It looks lik...

You could almost be fooled into thing this Is going to be a guitar. I’ve got a small design flaw on my part, the lower horn, despite taking more of the thickness out is still in the way at the last fe...

@robin turns out that I needed very little in terms of carving for the belly and wrist carves so they’re both quite slight. In might need to carve the lower horn out a little more to allow better acce...

That is looking good @tej! you got it under control 👍

Coming along nicely @tej 👍😁 🎶🎸🙂🙏

More routing and rounding, also have the holes for the wiring, socket and strap pins done (no pic of that bit!) Onto carving next, happy days. 🙂 Attachment : 7CB47523-BFA6-4DF5-9B80-B0E300...

RoutyMcRouterson Attachment : 1631994A-73E4-4F08-B6E9-63BD10E052AC.jpeg Attachment : 65407720-C8A8-4CE4-BE08-0C5EEBD2AFC9.jpeg I use a bit from radian tools, really not impressed with th...

@rocknroller912 Absolutely, I think a lot of what I’ve done will be used again though 🙂 At least it will if I have my way 😬 The effort for most jobs done well goes into the preparation...

@tej Its always difficult making a one off design because a lot of time is spent refining the process then it’s never used again.

@rocknroller912 I like that idea too, it does however presume I’ve got the sides even 🤔😉 I’ve got to remake the neck pocket template anyway after so will make it long this time, I thin...

@tej I get your idea now. I usually align the neck with a straight edge along each side of the neck and make a pencil mark on the body from the outside of the straight edge. Then I measure the distanc...

@rocknroller912 exactly the same as the one I’ve made but the back of the template would go to just before the edge of the body past the bridge. If I align the centre lines on the pattern and body at ...

@tej That sounds interesting but I cant imagine what it would look like. Have you got a plan.

@rocknroller912 Thinking about alignment I’m contemplating extending the template to the length of the body pretty much so that way I’ll get the smallest margin of error with alignment, in theory!

@tej looks like you are getting the hang of guitar building now, making your own jigs. In the past I’ve used a neck template that was slightly bigger than the pocket template so it doesn’t quite fit i...