@bonnywood Hi have you done any builds yet

Cheers @bonnywood, welcome to the club! Matt

My little rest piece polished up quite well so I've gone ahead and stained the body. There was a little flaw in the body that I had to fill and it didn't take the stain very well. So I mixed some dye ...

That looks fantastic @bpower, well done.

I would like to first say a huge thank you to Mark, Carol and the team at Bailey guitars for providing this platform for me to achieve a huge goal of mine. I just finished my first acoustic build. Spr...

Attachment : 510e2VFR-kL._AC_SY580_.jpg

The picture attached to my post shows guitar that I stained using water based stain from Crimson guitars. I've also used it on an acoustic and again it was pretty easy to work with although not very n...

@chrisot I've got the starter pack of Rustins for my finish experiments (I'm going to be trying different topcoats, stain, sealer and filler combinations on small test pieces, so I think the small qua...

Attachment : 913Mn6iu6uL.jpg

My favourite song today is one we play with the power trio I jam with every now and then:

This is My Favourite Song For This Moment..... should have been bigger than they were. 🎸🙂🎶🙏

The A string. The angle of the photo sort of hides the issue a bit. The tuner needs to move about 2.5 mm to the left so the strings fan out evenly over the headstock. A design mess up on my Thought I ...

@usadave Personally I think you should leave it and move on. Unless you replace the headstock veneer the repair will always be visible and that is probably worse than a tuner that’s slightly off. Plus...

Minor, I would roll with it the way it is. It looks freakin amazing. Wait til you put the finish on. It is honna be gorgeous. Top job man!

@usadave I can’t see anything wrong, which tuner is it.

HBs or P90s? P90s!

I have a pretty good idea on what you are going to do @tv101. It will be the most epic bandsman. The BM101 series. Haha.

I have recently taken to using Rustins Plastic Coat which is a two part. Can be brushed on or sprayed. Applying several thin coats about an hour apart and then ready for polishing after about two days...

That advice is almost too smart! well said, thanks man!

Hi everyone, so my project continues however one of my machine head holes is driving my ocd batty so I’m considering moving it. How would one go about doing that? Dowel and redrill? Fill it with black...