Here’s a tip for ya! Be very careful with fret wire, it’s extremely sharp on the ends. I sliced my hand open a few days ago with with a straight length of it, man it hurt and it’s still hurting now. ...

I am going to call this back done. Went over it with 1000, 1200 and 2000 grit, then rubbed menzerna rough cut twice, again 1200 and 2000 grit to get almost every speckle out, then again Menzerna 400 ...

@clinton 😯😍😍😍😍😍😍😍😍😍😍😍😍😍😍😍😍🎯💯

4th Bass Build Attachment : 6B1954CC-BC39-48EA-8ECF-9AEB175CAF5D.jpeg Attachment : 15DE9FA3-C37F-4582-B7F9-20CD34689F3E.jpeg Attachment : 9801458A-6BA8-4B87-9FE8-F8A573AFBA33.jpeg ...

@darrenking I’m just home from the pub and have to agree

@koendb I think it’s on the web site

Posted by: @rocknroller912 I think there is a 335 course planned and several people have shown interest. Yup ! I am definitely interested in that

I’ve never had a telecaster so I’m tempted to do something like that as a first project. I’m also keen to hollow body something like a 335 but I think that maybe too ambitious to start with.

Very nice job there @koendb. 🎶🎸🙏🙂

@koendb It’s looking really good, that’s a nice lustre. Just think that each grade of sandpaper puts finer scratches in the finish than the last one. The same goes for compounds and polishes, they are...

@koendb Yes I agree it’s starting to look very good

I think I am getting closer and closer to where I need to be.12 coats of shellac ( max 3 coats a day ), sanding back, shellac, sanding back.. etc..Especially yesterday, after starting to wet-sand ( Th...

@markbailey I did notice there are currently a lot of members online that don't look like your typical guitar builders.

the captcha filter is not working for everyone - just found out 9:45 pm having some issues myself ! Will get sorted tomorrow Apologies. M ------- Hi guys - Just a quick message about SPAMMERS!! The ...

@dirtbike. Welcome Nick. Enjoy the ride. It does say that you can get the free ebook when you sign in but it's been so long since I signed up I can't remember how you access it. I'm sure you'll have...

Hi All, I’ve been binge watching Marks videos on YouTube and think that they’re great. I’m hoping to start a project later in the year and I’m slowly accumulating tools and knowledge. The register lin...

Finally got this Jimi Strat in its flow coats today. It can cure for a couple of weeks before the final flat and polish. I’ll shut up about it now until I’m putting hardware on it. Attachment : 4...

Spent a couple of hours sanding this batch of clear coat flat, ready for flow coats. Attachment : 3AD2D044-4752-4A82-B442-3487C4972F3E.jpeg Attachment : DD689EF2-0340-4A2D-9FA1-09AC6B621E0...

Well, I think I am slowly getting better results. My shellac/Alcohol mix ratio is probably better. Before it was way to thick. More alcohol seems to be the right answer in this case 😉It is nowhere nea...

Posted by: @clinton No I am not because I dye it. If you apply sanding sealer, doesn’t it seal it to where you could not stain thereafter? @clinton I would fill the grain, sand it back, raise the g...