Today I’ve also drilled holes for other bits of hardware hardware and test fitted it all. Attachment : 10718FD6-78B9-4E6F-B749-724613886D26.jpeg Attachment : 554F286B-8E8D-4D5D-896B-ABF4C8...

Nice one. I used to airbrush. Not guitars. Back in Art school days. Time to get creative Boo. Can’t wait to see results! @clinton Oh that’s good to know. Ive got to get practicing my techniques and ...

Just thought I would show off my new painting gear. Iwata airbrush and compressor, with a BenchVent extractor (with filters). Can’t wait to get going with these Createx paints. Attachment : 5E346...

I'll talk about this on the livestream tomorrow if that is OK with you lot?

@clinton Nice one, sounds like you‘re pretty awesome in the kitchen as well! I also used to cook for a living, hard fookin‘ work. But one time some friends and I were at a restaurant up in Marin Count...

I was star struck in awe and deeply honored hearing that and coming from a guitar legend, the one and only Carlos Santana. @clinton Ha! Great story. I must come and try them for myself.

Hi guys. Thought I'd share my fist (and currently only) attempt at a BYO. Went quite well, if I might say. And she's matured really nicely. Mahogany neck; Ebony fretboard; Swamp Ash body; Wenge cap; G...

P90’s planned for my build number 2, sounds like Wilkinson are a good recommendation, thanks.

Wilkinson P90s are my new fave pickups and I cannot stop raving about it. @clinton I got some too. 🤘😁🤘🎸 Attachment : 0B1B2390-8834-4C88-9428-0F018A8FA64F.jpeg ...

@boo Dude, check it out: I was just on the Siggi Braun website and they‘ve got a guitar for you! Attachment : image.png

Fixed the problem today. Made a cylindrical drill bit out of some brass tube and cut some teeth in the end of it will a Dremel. Drilled the snapped drill bit out using a drill guide for stability. I t...

Howaa! It worked. 2mm walnut veneer ca glued over plastic humbucker rings. Been contemplating doing it. Adds a nice touch I must say and can be oiled. @clinton Ha, what a great idea, I’m glad it work...

Nicely done. Truss rod routing is so rewarding when it sits in the groove all snug! Getting a tight fitting square level Nut is my current nemesis

Control cavity routed now and body shape cut, I'm impressed with how square the bandsaw can cut. I've wedged a temporary piece into the neck pocket to prevent me knocking lumps off when I route the bo...

Well that's pretty much the most woodwork I've done in my adult life 🤣 I think it worked out ok, onto the headstock angle jig next. Attachment : neck_angle_jig.jpg

Yup, there goes @clinton, our resident frame saw wizard!

Attachment : 20210112_105932.mp4 Neck for Driftwood guitar. Ash Fretboard Sycamore Neck

Sawing that fret board is something else, I would definitely arse that up! Well done.

You're certainly a very skilled craftsman Clinton. Looking good. 🙂🎶🙏🎸

@clinton looks cool, f-holing sounds kinda rude 😆