Drill hole n scrap piece to test the pot. If hole is too big then plug with dowel on the mistake and redrill.

@blake Japanese parts are typically really good. The difference in hole size isn’t much as @frocesterbill pointed out. Just be sure to use a lock washer (already necessary) inside the cavity for good ...

These ones are made in Japan and not sure of brand. I think I’ll proceed and see how they feel with the slightly large holes. I better start checking things twice

I've bought Alpha and CTS and have to say the Alpha's are built better and turn more freely etc. @rockpile99 I like the Emerson Pro CTS pots. Good build quality, tight tolerance and a smooth turn, ni...

What they said above ... (though I suppose some plumbers ptfe tape around the threads would tighten things up but that's definitely a bodge) As an aside for any non-kit builds, knowing your pot dimens...

Yes - you are only 1mm too big - leave it - by the time you have a washer and nut and knob it won’t matter......

@blake Ok, if you haven’t routed the cavity yet then you could simply dowel the holes and start over if you prefer. Once the nuts, washers and especially the knobs are on, no one will ever see it. The...

Hey Matt, thanks. I’m not sure if they are CTS. Will have a look tomorrow. But I measured the diameter and they were just under 8mm. I haven’t routed the cavity yet. cheers Blake

@blake Not sure which pots you plan on using but CTS require a 9.5mm hole so I think you’ll be fine.

Hey @blake Have you only drilled the holes through the body or have you already routed out the control cavity?

Hi all, I’m making decent progress on my first build with the GM kit, but have made a silly mistake and grabbed the 9mm drill bit instead of 8mm for the pots. Is this something likely to cause issues...

Thanks Peebee It's in my Dad's hands now, so hopefully he's enjoying it.. cheers Steve

That is a nice build and a great finish, nice job.

Thanks Clinton there were a few false starts with them..I finally got hold of the right size grub screws.. cheers Steve

Good job. Wooden control knobs. Nice touch.

Hi Matt Thanks for the comments...I am a director/camerman (or at east was before covid!!!), I took some of the pics but a cameraman friend was bored and wanted to try some guitar photography so he di...

@steveadams Your guitar looks killer! Great job for sure and the pro photos really help it shine. Are you also the photographer?

Hey Boo Thank you..I have made a couppe of telcasters and came across Mark's site. I used his course for the necks and was so pleased with the rsults... This guitar was new challenge, carving etc...I'...

@steveadams It’s a wonderful finish Steve, what oil did you use. I think the whole guitar looks wonderful. Well done.

Hi Guys I think Attachment : RedStock-1038.jpg I ran out of room for some finished pics... cheers Steve Attachment : RedStock-1075.jpg Attachment : RedStock-1040.jpg Attachme...