Neck looks beautiful BTW! 😲 👍 Thanks, appreciate the comment! I’ve got a droplet sat on it now, presuming as the grain is pretty tight it’ll take a fair while to absorb. Next job is t...

Neck looks beautiful BTW! 😲 👍

Fingers x'd 🤞 The dent will raise as the water dries - sometimes it takes a few goes... I'm sure whatever is left will easily sand out or come out when you round over the end.

@markbailey This is the dent (bottom left) I was talking about. I’ll opt for the drop off water first and see if that helps before trying anything more severe! Attachment : BE026BE3-48B5-4C35-B542...

…not abalone, mother of Pearl! Oh for an edit function that works!?!?!?! I’ve MOP for the side dots too but they’re very thin so need to make sure they’re only very marginally proud when glued in so I...

Coming along nicely @tej. 👍😁 🎶🎸🙏🙂

@koendb thank you 🙏

@Tej Looking good man!

Dots are in, 5mm abalone. I used a depth stop on the drill bit to keep everything consistent as opposed to eyeing it in which worked a treat. For the super glue I let a small drip run down a cocktail ...

Progress very much ground to a halt again after life got in the way! I’ve modified the neck workboard now so it has a 4 threaded inserts in that I can screw a support into. The support I made from an ...

Side dots all done, 1.5mmx1.5mm MOP, most awkward part of the build yet. I’ve drilled one of the holes for the 24th marker out of line, thought it was just a little out when I did the hole but with th...

@robin no I masked off the fret wire and sanded with the grain. I’ll do a small test with some lemon oil to see if it magically vanishes and if not I’ll redo them all the same. I suspect the same as y...

@tej . I’ve managed to clean it up fairly well but now the wood is lighter on two frets where I’ve sanded and scraped. Were you sanding across the grain to get close in to the fret wire. Try sanding...

@koendb Thanks. It will definitely improve as I’ll clean up the whole board at the end which will leave a much more uniform look too if nothing else. I suspect the lighter colour is tiny particles of ...

things had been going so well it was a little disheartening! Yeah I know that feeling all too well :-/You might be able to get rid of it by sanding with very fine wet n dry.Eventually, even if you do...

@koendb I was careless filling the fret ends and on two of the frets the glue ran over the front of the board. I’ve managed to clean it up fairly well but now the wood is lighter on two frets where I’...

Superglue + fretboard = sadness What happened?

Superglue + fretboard = sadness

@rocknroller912 exactly the same as the one I’ve made but the back of the template would go to just before the edge of the body past the bridge. If I align the centre lines on the pattern and body at ...

@tej That sounds interesting but I cant imagine what it would look like. Have you got a plan.