Love the way it feels! @clinton That is amazing, it sounds great and I love the way it looks. Fantastic work, as usual. I always look to you for inspiration and I need to get my box guitar finished. ...

Woah @clinton! That neck wood looks incredible!

I’ve used a round file before. I use a really fine, thin, round file @boo I’ll have to look at the type of file you’re talking about, I have a half round mini file that might to, between that, @rock...

clean out the finish build up from post holes by running a sharp knife carefully round the inside @rocknroller912 thanks for the idea, i think the initial layers will be cured hard by now, I can test...

One thing I would advise though is that you mask up the neck pocket at least, @boo yeah I figured that a few coats in, masked it up and then started removing it between coats as it was building up a ...

@tej For stuff like that, I’ve used a round file before. I use a really fine, thin, round file (a chainsaw sharpening file). Be careful just to push the file down into the hole and along the top edge ...

@tej Its possible to clean out the finish build up from post holes by running a sharp knife carefully round the inside. I know this sounds scary but the knife will take paint off without damaging the ...

Progress on the body finish @tej It’s looking superb. One thing I would advise though is that you mask up the neck pocket at least, it doesn’t matter too much about the pickup cavities. 👍

Progress on the body finish Attachment : 14C657EB-30F3-4520-9B4C-DB394F56A706.jpeg

@tej What I’m thinking now is to do that to get the built up finish off and then colour the hole with soft graphite pencil lead and go over again until I’m back to wood, I think I only need to remove...

@robin, with regard to masking the holes, I meant I didn’t do that, not that I don’t intentionally! That said do you know how you would go about this?

I hadn't masked off the bridge post holes when I lacquer my current build @robin ok, so I don’t do that either but I like the solution. What I’m thinking now is to do that to get the built up finish ...

@tej Only concern now is that the bridge is a very tight fit in the mount holes, I hadn't masked off the bridge post holes when I lacquer my current build, so the holes have shrunk with all the lacq...

There are a lot of tools you can buy for guitar building that would break the bank if you tried to get them all. What I can not afford I try and build until I can afford to get the nice stuff. For in...

I finally got it out of a state of just hanging around to a state of getting all the hardware on it and getting some strings on it. I’ve done a quick setup and it plays beautifully. All I need to do n...

I got the frets in this thing. Evo Gold 3mm Jumbo ✨🐘 Attachment : 79E3277A-0799-4519-A00C-6732E5E4EECC.jpeg Attachment : 92A4F846-6389-46D8-8917-956EF562A638.jpeg

I’m not putting a reamer anywhere near this build, bad experiences with them, if it comes to it I’ll make some tedious sanding tool and do it very carefully. I’ve some scrap to experiment on but I wan...

t was a little scary. @boo I’m not putting a reamer anywhere near this build, bad experiences with them, if it comes to it I’ll make some tedious sanding tool and do it very carefully. I’ve some scra...

Only concern now is that the bridge is a very tight fit in the mount holes, at least it is in the test ones, I meant to address that before I applied the finish but didn’t stupidly. Just hoping enlarg...

I’ve somehow missed all of this I’ll not take your previous silence personally @boo 😉 Only concern now is that the bridge is a very tight fit in the mount holes, at least it is in the test on...