where can I find his livestreams can see a link from Here too them. Am I missing the obvious Here? @tej: Workshop Weekend Sunday Special !! Building a guitar at home - Making a Thru Neck Guitar

you want/need consistant clamping pressure across the wood and that’s going to be hard with a profile cut into it. On the other hand pretty unwieldy to cut once the next is attached though with adequa...

@koendb But your wings should already be roughly shaped. So this is one of the parts I was really unsure with, I’d assumed you wouldn’t cut them to shape as I’d expect you want/need consistant clamp...

I’m sure Mark did a live stream on neck through construction. @rocknroller912 where can I find his livestreams can see a link from Here too them. Am I missing the obvious Here?

I challenge you to cut those horns with a router. @rocknroller912 or perhaps a sharp spoon!?

@koendb I’m sure Mark did a live stream on neck through construction.

Ok if it’s too quiet I’m up for stirring the pot. I challenge you to cut those horns with a router.

I’m not familiar with the approach for neck though, at what point do you join the wings on to the neck? @Tej I don't know yet. This would be my 3th scratch build and first one with a neck through.Thi...

mighty quiet in here of late!? Yes it is really quiet the last couple of weeks. I guess life is catching up again 🙂

@koendb v4 for me 😬 If you still had an asymmetrical end but took the curve from the lower wing through the neck end into the top wing I think that might look best, to me at least. So it would...

V2: Correct Bridge and angle slightly lowered into middle section Attachment : NeckTrough-2.png V3: Hump in bottom half of the body slightly removed Attachment : NeckTrough-3.png V1, V2 ...

The bridge is already decided and I have it in my drawer 🙂 I think a bridge with a separated tail piece is a stupid idea, if I were you I’d have a look in your drawer to see if you have somet...

You could always use a bridge with a separate tailpiece to occupy some of the bump? The bridge is already decided and I have it in my drawer 🙂I just need to alter the plan

@koendb You could always use a bridge with a separate tailpiece to occupy some of the bump?

Had to contemplated taking the angle from the centre line incorporating the end on the neck into it? AS a matter of fact, I did. But You do have a point though, if you look on the original drawing, t...

@koendb I think what doesn’t sit right is the curve into the flat end of the neck then the angled take off on the top wing, it doesn’t look intentional. Hard to explain where I’m coming from here. Had...

I’d make the angle the top wing comes off the bridge end of the through neck more shallow, it looks a bit harsh to me which doesn’t quite work when the other wing smoothly curves. @Tej thx for the co...

@koendb like it! A couple of points, personally I’d make the angle the top wing comes off the bridge end of the through neck more shallow, it looks a bit harsh to me which doesn’t quite work when the ...

This is what I came up with reshaping an existing plan Attachment : NeckTrough-1.png

I’ve only ever owned 25.5” scale guitars, I tried to play as SG copy that had a shorter scale length and simply couldn’t play anything well at all, felt very alien everything being that little bit out...