Redrawn the posts in the correct position.

@peebee Yeah that’s better, exactly that. 👍

@peebee This video is for positioning the wraparound bridge in the correct place and to mark where the post holes are to be drilled. 
https://youtu.be/tJGbKStlkb8

This forum is great eh? Plenty of advice and help to be had, I am sorry I didn’t find it sooner @peebee I’ve just made another short video regarding the bridge position for the wraparound bridge. I’m just uploading it…   Read more»

@peebee It’s looking good but I can’t see where the scale length line is. Make it really clear so you can’t overlook it. Also, if you are using the Wilkinson wraparound bridge, have you measured 6mm back from the scale length…   Read more»

@peebee Have a look at my video for the Wilkinson wraparound bridge and double check your drawing. https://youtu.be/RLjt4KkyGF4 

The drawing so far. Now just going to look at it and decide if it’s right. @peebee It’s looking good but I can’t see where the scale length line is. Make it really clear so you can’t overlook it. Also,…   Read more»

@peebee make sure your tuners line up and that the horns on the headstock are not in the way of the pegs of your tuners. Looks like it may.

@peebee thanks Peebee and Darren I’m happy to epoxy the pin in…I dont see why I should want to remove it… bit frustrating as I bought the 11mm bit especially for this job. I had a quick look, 11.5mm seems…   Read more»

@peebee

Robin, you are the master of doing a great job with the minimum of kit, hats off.

If only I had a hat, it would be too cold to take it off. 🥶🏴󠁧󠁢󠁳󠁣󠁴󠁿🙂

@peebee I then stuck to some 18mm mdf, bandsawed the outline and finished on the bobbin sander. Our local B&Q was out of 18mm mdf so iv’e had to settle for 12mm. I bought a 4’x2′ sheet that I’ll use…   Read more»

@peebee
Your drawing looks great, which bridge do you plan on using?

@peebee
Nice one! Plus you have a bobbin sander, sweet! Is it one of those combo jobs with a belt or a proper “up-n-downer?”

this is even more difficult than I thought! @peebee maybe at first it may seem difficult but before you know it, it will become second nature and you won’t even need to think about it much. Keep going and ask…   Read more»

Right here goes starting the drawing, the rules are out, a roll of lining paper, some pencils and an eraser. PRS double cut style with P90’s as I don’t have a guitar with those pickups. @peebee Yeah! Show us your…   Read more»

@peebee
Sounds awesome, have fun!
 

@peebee That’s a lovely build, well done. I like the neck joint, very smooth Thanks Peebee, that shape was a bit accidental, I had to keep cutting away to get rid of a notch I dug with the router. Now…   Read more»

@peebee Turned out really nice. Surprised at the potentials Mark unleashes following his online courses. Truly is the best.

@peebee I’ll have a think about it. Could be a very low cost CNC project.
Regards
Darren

Here’s the garage….everyone loves a workshop pic.

@peebee Yeah great workshop space, perfect for guitar building. 

Here’s the garage….everyone loves a workshop pic.

That’s a decent workspace @peebee – and looks suitably well used too!