Side cut only no bottom cut for laminate trimming. I guess this is the type you will use in your router table.

Brian
Side and bottom cut. You would use this to plunge a small hole maybe 2 mm deep and then side cut.

Brian Starting the router with the bit in a pre drilled hole might be dangerous unless it’s a very big hole. It might cause a kick back. Better to use a bit which has bottom cut and go down to…   Read more»

@jamesbisset  I once removed a bridge that was glued with Titebond type glue from a factory guitar using a domestic iron and some brown paper. Heat does soften the glue but you have to be paint and go slowly to…   Read more»

@boo 
Ive learned the hard way

@jamesbisset 
I know I’m a smart ass being wise after the event but I use water based glue for anything I might want to remove.

@boo 
Accepted your request thanks. I wondered who it was and nearly declined as I’m getting bombarded with scammers at the moment.

@anisahsheikh 
Even experienced makers still find there are new things to learn

@nsj 
I read on another forum that evo gold supply problems are due to the foundry which makes the metal not being able to source raw materials 

@koendb 
Fantastic work, it’s great to see someone using hand tools and not doing everything by machine. 

@clinton
Thanks this is useful, I thought that shaping the veneer before gluing would be needed and didn’t think of a heat gun.
@jamesbisset
looks like this method works  

@clinton 
Thanks there is some discussion at the moment about using veneer and finding a method that works, so I thought you might have the secret 

@clinton 
Looks very professional, is the top carved from solid wood or veneers glued together.

@koendb 
Good to hand tools being used