@marcel Brilliant recording especially in one take

Posted by: @tv101 Oh, and minutes (at least 3) to listen to all the good stuff posted by @marcel too. 🤣 🤣 🤣

Posted by: @wayne_f Shimming would probably be the best solution, right? @wayne_f Yeah, glue a veneer of equal thickness on each side of the neck heal. When dry, test fit the neck to see if you hav...

@wayne_f Shimming would probably be the best solution, right? I think we've all done that, the neck can be a good tight fit in the routing template but the pocket ends up bigger. Take a shaving of...

Routed the neck pocket today but not quite to full depth. Then I went to see how the neck would fit. That's when I was hit with a little disappointment. The neck heel sits loose in the pocket. Att...

Posted by: @tv101 Congrats @tej Its addictive. You build one, build another, build another and before you know it, you’ve built 20. And still want to build another. I concur. 🎯💯
...

Posted by: @tv101 Where'd @steveadams go to?? @tv101 not sure, not seen him for ages.

Where'd @steveadams go to?? Loved watching these mini-vids, good to see another learner-builder putting something together with all the little challenges that us learner-builders stumble into ... an...

Did some doodling on the bridge assembly. The plan is to make a few from aluminum to get the size and shape correct, and get the saddles to adjust properly. Then, I'll machine them from something hard...

Posted by: @tv101 just been busy with "life" 'n' stuff, so done no building for a few months. I had some grand plans involving some Bagpress bits, but then life happened and I've not even opened the...

Posted by: @boo Hello stranger, how are you doing T? Hi @boo - just been busy with "life" 'n' stuff, so done no building for a few months. I had some grand plans involving some Bagpress bits, but t...

Posted by: @koendb That is actually a practical solution used.. So chances are, if an engineer ever asked you to push a fader at the end of a desk, you where being a little annoying to the rest ....

Posted by: @tv101 Attachment : image.png That is actually a practical solution used.. So chances are, if an engineer ever asked you to push a fader at the end of a desk, you where being a lit...

Hello stranger, how are you doing T? @tv101

Attachment : image.png

Attachment : image.png

@russ You should change your web handle to slow hand, or is that one taken already.