Seth
,@seth
-
Seth liked forum post "Neck grain runout" – 4 years, 7 months ago
-
Seth replied to the topic "Neck grain runout" – 4 years, 7 months ago
@darrenking thanks, that’s what i was hoping to hear, I will proceed forward then. the worse case scenario is the neck does break, so this will be a bolt on lol
-
Seth liked forum post "Neck grain runout" – 4 years, 7 months ago
-
Seth posted a new topic "Neck grain runout" – 4 years, 7 months ago
Im going through the courses while making my first build, Mark had mentioned side grain runout causes a week point in the neck, which sucks because the piece of maple i though was great is now causing me concern. Do… Read more»
-
Seth replied to the topic "Fret sloting oopsie" – 4 years, 8 months ago
Thanks Darren
-
Seth liked forum post "Fret sloting oopsie" – 4 years, 8 months ago
-
Seth replied to the topic "Fret sloting oopsie" – 4 years, 8 months ago
Yes its off by 1mm. I measured with a little $9 angle-izer.
-
Seth posted a new topic "Fret sloting oopsie" – 4 years, 8 months ago
Hi everyone, just started my first build, i was cutting the fret slots by hand and some of the slots are off by 1°. Is there a tolerance? Is there anything I can do, or is this fret board destined… Read more»
