Thank you everyone, I appreciate all your help.

@robin yes please post a picture! Yeah that’s what I’m leaning towards doing, im just wondering if it’s enough support after watching a repair video that had mentioned something about necks leaning t...

So I realized this after cutting the neck slot on my LP style body that I shouldn’t have made it the same size as the neck, I should have made it more narrow and the cut a channel in the neck to go ov...

all cut out and ready for final cuts with the router. Attachment : A537D64B-C042-43A8-9E84-580B23AB9A9F.jpeg

@robin NICE! Yeah i just did the rough cuts for the shapes this morning before work. I couldn’t make up my mind of what to make, so im making two at the same time, both have mahogany bodies but one is...

@darrenking thanks, that’s what i was hoping to hear, I will proceed forward then. the worse case scenario is the neck does break, so this will be a bolt on lol

Im going through the courses while making my first build, Mark had mentioned side grain runout causes a week point in the neck, which sucks because the piece of maple i though was great is now causing...

Thanks Darren

Yes its off by 1mm. I measured with a little $9 angle-izer.

Hi everyone, just started my first build, i was cutting the fret slots by hand and some of the slots are off by 1°. Is there a tolerance? Is there anything I can do, or is this fret board destined fo...