@Tej You are on a roll! nice work!

@tej 
It all looks very neat even the bit you said is a mistake

Cheers @tej 😀 

@tej Plans are great but they often don’t survive first contact with the wood because it has a grain that sometimes takes you where you don’t want to be. There’s always the human factor of course but that’s part of…   Read more»

@tej  A big part of being a maker is how well you can get out of your mistakes, and you are managing it very well so good job. Everyone makes mistakes, the trick is to hide them. I’ve been watching…   Read more»

@tej that is looking awesome ! good job

Is it like that the whole length?

@tej No, it starts from about the 12th and gets steadily worse going towards the nut. 

@tej

So you need to play around with the neck angle whilst there is still enough meat on the neck heal, taking very small amounts off each time. That’s really what it comes down to @Tej – trial and error, but…   Read more»

Any advice when it comes to the neck angle By the way? Seems like a critical point with little science involved to get it right? @tej It all depends on what bridge you intend to use. The best way is…   Read more»

For anyone who’s interested there is a lesson in the Acoustic course on laminating headstocks. 

Just watched that 2-3 weeks ago @tej. All good stuff. 👍😁 
🙏🎶🎸🙂

@russ so I mentioned to Mark about this and I need keep the headstock “core” over 13mm

That’s good to know @tej. Mark’s knowledge is invaluable to us.
🙂🎸🎶🙏

So what’s your plan for this repair @tej? Glue on one veneer then drill out the four tuner holes and then repeat?

Hi @tej. 
If you haven’t already glued it down, you could rout another 1mm off the headstock. If you have then be very careful not to rip it off with the router. Maybe you could just sand it down. 🤞 
🎸🎶🙏🙂

@tej It’s neat isn’t it?That guy builds a lot of very cool things, including most of his workshop, and always to a really high level of precision.

So the dowel cutters I have are utterly useless

@tej, I saw this video just recently.

@tej I have one of these hammers too, they do the job nicely. 
https://tonetechluthiersupplies.co.uk/summit-fretting-hammer-27mm.html

@tej As @russ said you can never have too many clamps. 🤣

I know @tej. I could spend a fortune…..if I had one. 😂🤣 
🙏🙂🎶🎸

@tej I found these diamond stones in my local diy shop a few years ago. They are ok for the price and I use them for all my chisel and plane sharpening, held in a vice, to set the micro…   Read more»