Hi John - I had a good look at the images...the good news is that it is far from a disaster...Looks great! The width at the nut is supposed to be 42mm and it measures 44mm, Ahhhhhhhhhhhhh...............

@markbailey Hi Mark Yep I got a dessicant one. Seems to be doing the job. You can set it to run for so many hours (2-23), set the humidity (40/50/60/70% etc). Its not too loud as I haven't tried it o...

It works well without the feed tables but I am looking at making something up for peace of mind ? I have an Axminster Craft AC82E as the main dust extractor with blast gates to seperate the bandsaw, ...

@frocesterbill Hi Bill. Yes they released a new version from Jet and Axminster got them in and it was slightly cheaper than the older one or the Bayleigh alternative. So just had to go with one. Carri...

Well its been a while since I last posted about the RH level problems in the Garage/Workshop conversion I have been doing. Partly because I have been on another course with Marrk on a new Set neck gui...

Shit just saw this post after posting my similar experience. Maybe we just keep our guitars outdoors once we've made them 🙁

Yesssssssssss!!! Finally! I win something ?

I am from t'Netherlands.... Nuff said................

I sense a Monty Python Song coming on. Never knew you were from't Yorkshire Mark 🙂

Blimey....... I wish..... ☹️ And here I am in my 2x3 meter shed.... Or in front of it.... Guitar building is mainly an outdoor activity for me! Looking great ?

Thanks John I am by no means a builder just keen DIY er. Taken advice from some friends who are builders. All the vertical 4x2 pieces are side on and battened 1"off the wall and have damp proof membra...

Ha Ha just found this link that says attach files could be the answer 🙂 Attachment : 7 Rear completed and right side almost done.JPG Attachment : 6 Left side completed.JPG Attachment : ...

Thanks Darren Yes I know the propane heater is a no no. just needed to see if the RH level could get down to anything close to a working environment. Which it did so will continue with the insulation ...

Yes I have read the dessicant ones are better for workshop/garages. didn't know about the temp reason though 😉 I will try and get some pics up to the thread but not sure how atm I have already covered...

UPDATE Ok two dehumidifiers going 24/7. One 2500Watt oil heater left about half way up on the thermostat, to keep the frost out over night. So two days later at 9 am and the RH level is down to a stea...

Great Q - Thanks! Yes it can be a bit of a nightmare in a draughty shed. In the middle of winter...in the UK... If you do not have any 'proper' heating available then I believe that the best solution ...

I have a question regarding humidity for you Mark. Do you use a dehumidifier in the workshop and if so which one would you recommend. Or is there another way? The garage I am in the process of convert...

@darrenking, @david-johnson09 Thanks guys. I will call my neighbor to cut them next week. Have to figure out somewhere to keep them for the winter...

@darrenking, @david-johnson09 Thanks guys. I will call my neighbor to cut them next week. Have to figure out somewhere to keep them for the winter...

@darrenking, @david-johnson09 Thanks guys. I will call my neighbor to cut them next week. Have to figure out somewhere to keep them for the winter...