Blimey....... I wish..... ☹️ And here I am in my 2x3 meter shed.... Or in front of it.... Guitar building is mainly an outdoor activity for me! Looking great ?

Thanks John I am by no means a builder just keen DIY er. Taken advice from some friends who are builders. All the vertical 4x2 pieces are side on and battened 1"off the wall and have damp proof membra...

Ha Ha just found this link that says attach files could be the answer 🙂 Attachment : 7 Rear completed and right side almost done.JPG Attachment : 6 Left side completed.JPG Attachment : ...

Thanks Darren Yes I know the propane heater is a no no. just needed to see if the RH level could get down to anything close to a working environment. Which it did so will continue with the insulation ...

Yes I have read the dessicant ones are better for workshop/garages. didn't know about the temp reason though 😉 I will try and get some pics up to the thread but not sure how atm I have already covered...

UPDATE Ok two dehumidifiers going 24/7. One 2500Watt oil heater left about half way up on the thermostat, to keep the frost out over night. So two days later at 9 am and the RH level is down to a stea...

Great Q - Thanks! Yes it can be a bit of a nightmare in a draughty shed. In the middle of winter...in the UK... If you do not have any 'proper' heating available then I believe that the best solution ...

I have a question regarding humidity for you Mark. Do you use a dehumidifier in the workshop and if so which one would you recommend. Or is there another way? The garage I am in the process of convert...

@darrenking, @david-johnson09 Thanks guys. I will call my neighbor to cut them next week. Have to figure out somewhere to keep them for the winter...

@darrenking, @david-johnson09 Thanks guys. I will call my neighbor to cut them next week. Have to figure out somewhere to keep them for the winter...

@darrenking, @david-johnson09 Thanks guys. I will call my neighbor to cut them next week. Have to figure out somewhere to keep them for the winter...

I’d store them on slats to let air get round them also try and I’ve heard to seal the ends or it will crack/split as they dry.

@david-johnson09 Attachment : IMG_20200831_125141.jpg Attachment : IMG_20200831_125058.jpg Attachment : IMG_20200831_125208.jpg Attachment : IMG_20200831_125042.jpg At...

@tv1010101 the workshop and the recording / rehearsals room are next to each other. Plus I am talking to a neighbor who's father is too old to run the carpenter workshop. @clinton the wood was just cu...

@tv1010101 the workshop and the recording / rehearsals room are next to each other. Plus I am talking to a neighbor who's father is too old to run the carpenter workshop. @clinton the wood was just cu...

Attachment : 691D3D81-5698-49EB-8244-5525BADE57C8.jpeg

@markbailey always check behind the ear it's the most likely place

@frocesterbill there is an easy way and I think Mark mentioned it in one of the live videos. French curves are a set of 3 plastic templates which have just about every curve and oval that you would ne...

They hide - sometimes to avoid being used by anyone apart from Mark...... Also if a live stream is running smoothly....... ?

The problem is that Mark has magic pencils Yes - they all disappear just when you need them!!