Interesting idea @mezy try on some scape and see how it goes. I’d be interested to see the results..

My planned archtop is going to require lots of binding, which requires lots of Precision Routing. My lovely partner (for it is she) has a Dremel MultiPro she says I can borrow. And StewMac (sigh) have...

Awesome. Do you carve necks with an axe @jamesbisset that’s extremely manly... seriously I saw a demonstration of a guy doing exactly that at Tonetech’s shop

Sorry @TV1010101 it looks like you already covered that point..

I’ve been trying thinking about the bridge. You should still be ok with a set neck but the angle may be shallower than say a W/o bridge. What height is the bridge? As long as the neck angle hits at t...

I meant to put in the post ...what I mean by glossy is the same paint and lacquer as one. It’s a similar process but not polished to a shine...it still needs filling (unless you want visible grain).

I agree with @TV1010101 mahogany would be nice. Could you not do a bolt on neck but glue it in. I’ve always thought bolt ons should have a slight angle in any case and that’s why some shim them. Pers...

Not a lot of crown left!!

They do look a bit flat top......

It could look classy if you plug nicely with a contrasting wood and re-route? I'm sure that's one of your ideas anyway...

OK - but make sure you understand this first: 38mm E-E with 42mm overall width only leaves 2mm each side - I would say this is not enough. After you have the angle on the frets your playing surface i...

Hi John - I had a good look at the images...the good news is that it is far from a disaster...Looks great! The width at the nut is supposed to be 42mm and it measures 44mm, Ahhhhhhhhhhhhh...............

@markbailey Hi Mark Yep I got a dessicant one. Seems to be doing the job. You can set it to run for so many hours (2-23), set the humidity (40/50/60/70% etc). Its not too loud as I haven't tried it o...

It works well without the feed tables but I am looking at making something up for peace of mind ? I have an Axminster Craft AC82E as the main dust extractor with blast gates to seperate the bandsaw, ...

@frocesterbill Hi Bill. Yes they released a new version from Jet and Axminster got them in and it was slightly cheaper than the older one or the Bayleigh alternative. So just had to go with one. Carri...

Well its been a while since I last posted about the RH level problems in the Garage/Workshop conversion I have been doing. Partly because I have been on another course with Marrk on a new Set neck gui...

Shit just saw this post after posting my similar experience. Maybe we just keep our guitars outdoors once we've made them 🙁

Yesssssssssss!!! Finally! I win something ?

I am from t'Netherlands.... Nuff said................

I sense a Monty Python Song coming on. Never knew you were from't Yorkshire Mark 🙂