Place the two pieces of the neck into the vice as shown in this picture and plane the joint flat and square and keeping the angle of the scarf joint. ...

Measure 90mm from the Nut towards the end of the headstock and mark the position of the scarf joint. I cut it using a scarf joint jig on the bandsaw. ...

I started by squaring up the neck blank. Planing one of the faces flat and smooth then squaring up both of the edges. I kept the blank wider than the ...

@nolanrathkegmail-com You certainly can use it for fretboards. I've seen it used a couple of times. You might be lucky enough to not need to fill in...

@dhawkes1gmail-com I agree with robin, Dan. Just mark a new centre line on the fretboard and bring the sides in evenly to match your neck profile......

@nsj Very close! Nice job. Really enjoying watching this build Neil. 🙂🎶🙏🎸

A bit of a closer look. 🎸🙏🎶🙂

All finished......🙌 Not quite........I forgot to put fret markers in so went back and fitted side dots It's not perfect but I'm happy with ...

Preparing bridge pin holes for strings 🎶🙂🙏🎸

Finishing.... with oil 🎸🙏🙂🎶

Saddle making 🎶🙂🙏🎸

More nut making 🎸🙏🙂🎶

Making the nut 🎶🙂🙏🎸

Sanding 🎸🙏🙂🎶

Leveling, crowning and polishing frets 🎶🙂🙏🎸

Gluing on the bridge 🎸🙏🙂🎶

Setting bridge position 🎶🙂🙏🎸

Knocking in some frets 🎸🙏🙂🎶

More bridge making 🎶🙂🙏🎸