Thank you!

Yes there were a few hairy moments. In fact on one of the cuts the router took a bite and exploded a chunk up near the toggle switch. I had to take a ...

Thanks very much, and of course I can. The best way would be with a table saw but at the time I started this I didn't have access to one so I used ...

Nice! Thank you. I'm actually in Fife, its just easier to go with a place more people will have heard of! So where abouts are you?

Do you have access to a CNC to use it? If so there will be an associated CAD program that the owner uses. I would suggest you start by finding that ou...

Whether or not you need a break angle will depend on the height of your bridge compared to your fret board. For example, if you wanted to use a tuno...

@russ oh, I'm aware! I've been on this project for 18 months so far and am nearly finished. But after this I already have the next 3 planned. These on...

Thanks Brian, I've not had a chance to look around the site much yet, but I'm sure there will be loads of good content to read up. My plan is tto do...